User manual SONY CDP-295 service manual

[. . . ] Using the Player with Another Component This section describes how to hook up the CD player to an amplifier. Be sure to turn off the power of each component before making the connections. Insert two R6 (size AA) batteries by matching the + and ­ on the batteries to the diagram inside the battery compartment. Insert the negative (­) end first, then push in and down until the positive (+) end clicks into position. [. . . ] Other discs Other tracks on the same disc Other tracks on other discs Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the programme, the display shows "­ END ­" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. You can have the player create a programme that will fit the length of the tape. The player automatically creates a programme, keeping the original order of the disc. The programme can contain up to 32 steps (a pause inserted between steps is counted as one step). Press CHECK until the track you don't want appears in the display, then press CLEAR. Each time you in the programme press the button, the last track will be cleared. Change the whole Hold down CLEAR until programme "CLEAR" appears in the display. Completely Create a new programme following the programming procedure. You can manually fade in or out to prevent tracks from starting or ending abruptly. 4 Turn l AMS L until the character As you turn l AMS L clockwise, the characters appear in the following order. 4 Press CAPS to find the letter type you The selected character lights up, and the flashing cursor appears to indicate the next space to be input. To do other operations, use the controls on the second player or the supplied remote. />) and search buttons (m/M) on the remote operate the second player as indicated on the remote. To control the second player directly using the supplied remote Set CD 1/2/3 on the remote to CD 3, which is the same mode set for the second player. To control this player again The MEGA CONTROL button goes off and you can control this player. Playing discs of the second CD player The MEGA CONTROL button lights up and the display shows the current disc number of the second player. You cannot locate a particular point in a track of the second player using the controls on this player. Some controls on this player work on the second player differently from they do to this player. Loading the Disc Names (Disc Memos) of the second CD player If the second CD player has the Disc Name (Disc Memo) function (see page 16), you can load the Disc Name (Disc Memo) of the second CD player to this player's memory and display them on this player. The play starts and the display shows the current disc and track numbers and the playing time of the track. [. . . ] Before operating the player, check that the operating voltage of the player is identical with your local power supply. The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. [. . . ]