User manual SOMMERKAMP TS-788DX

[. . . ] Failure to follow the instructions as concerns hood and filter cleaning will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted because of the possible risk of electric shocks. We decline any responsibility for any problems, damage or fires caused to the appliance as the result of the nonobservance of the instructions included in this manual. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ] Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Use a duct with as few elbows as possible (maximum elbow angle: 90°). Filter version One active charcoal filter is needed for this and can be obtained from your usual retailer. The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid. 15 Installation The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. The wall/ceiling must be strong enough to take the weight of the hood. Operation Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. Before beginning installation: • Check that the product purchased is of a suitable size for the chosen installation area. €¢ To facilitate installation, remove the fat filters and the other parts allowed and described here, dismantle and mount it. Charcoal filter signalling After a total of 320 working hours number "2" starts to flash on display. When this signal appears, the installed charcoal filter needs to be cleaned or replaced (according the model you own). To reset the signal keep the push-button 1 pressed for 3” until number "1" disappear from diplay. In case of contemporaneous signalling of both filters, numbers "1" and "2" will flash on display alternatively. The first time it resets the grease filter signalling, the second time it resets the charcoal filter signalling. In case the filter version cooker hood is used, it is necessary to activate the carbon filter signalling. Carbon filter signalling activation: Turn OFF the hood and keep the push-buttons 2 and 3 pressed contemporaneously for 3”. Numbers "1" and "2" will flash alternatively on display for 2”. Carbon filter signalling deactivation: Turn OFF the hood and keep the push-buttons 2 and 3 pressed contemporaneously for 3”. The system envisages the automatic function in two modes: - COOKING function that guarantees the correct suction of fumes during cooking. - AIR QUALITY CONTROL function that is a monitoring system that guarantees a high level of air quality. [. . . ] Selection of the hob This operation optimizes the automatic functioning of the cooker hood, proceed as follows: Turn OFF the hood. Keep the push-buttons 1 and 3 pressed contemporaneously for 3” until the hob in use is displayed, according the following letters shown on display: "g": Gas Hob "i": Induction Hob "e": Electric Hob The cyclical selection of the hob is obtained by pressing the 17 push-button 1 The acceptance of the selected hob is displayed through the sequence of 3 flashings of the letter related to the selected hob. Once the hob is selected, wait for 10” to accept the function. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. [. . . ]