User manual SMC BR14VPN

[. . . ] Package contents After unpacking the SMCBR14VPN, please check the contents of the box to be sure you have received the following components: · · · · · 1 BarricadeTM VPN 4-Port Broadband Router (SMCBR14VPN). 1 Power Supply. Hardware description The BarricadeTM VPN 4-Port Broadband Router router is equipped with: · · · · · 1 4 1 1 1 Auto-Sensing 10/100 Mbps RJ-45 WAN connection. COM connection for ISDN or external dial-up modem. There are 6 Front Panel LED Indicators: Immediately inform your dealer in the event of any incorrect, missing or damaged parts. [. . . ] LAN (100M) Green Solid LED indicates a LAN connection is detected at 100Mbps. Blinking LED indicates traffic is being transmitted through the WAN connection. No light indicates a LAN connection was not detected or detected at 10Mbps. LAN (10M) Orange Solid LED indicates a LAN connection is detected at 10Mbps. Blinking LED indicates traffic is being transmitted through the WAN connection. No light indicates a LAN connection was not detected or detected at 100Mbps. Status (Status) Orange System requirements To install and connect to the SMCBR14VPN, you must have: Note: A CD-ROM drive is only required if you want to use the EZ 3-Click Installation Wizard application to configure your BarricadeTM Router. The process can be completed manually through the web interface. FOR TECHNICAL SUPPORT, CALL: From U. S. A. and Canada (24 hours a day, 7 days a week) (800) SMC-4-YOU; Phn: (949) 679-8000; Fax: (949) 679-1481 From Europe: Contact details can be found on www. smc-europe. com or www. smc. com. INTERNET E-mail addresses: techsupport@smc. com european. techsupport@smc-europe. com World Wide Web: http://www. smc. com/ http://www. smc-europe. com/ If you are looking for further contact information, please visit www. smc. com or www. smc-europe. com. Model Number: SMCBR14VPN Driver updates: http://www. smc. com/index. cfm?action=tech_support_drivers_downloads BarricadeTM VPN 4-Port Broadband Router Quick Installation Guide Hardware installation Congratulations on your purchase of the BarricadeTM VPN 4-Port Broadband Router (SMCBR14VPN). This EZ Quick Installation Guide will guide you through a simple process to get your new BarricadeTM Router online in 3 mouse clicks. For additional information and advanced settings configurations please refer to the User Guide included on the CD-ROM. Before you can use the EZ 3-Click Wizard you need to connect your new BarricadeTM Router to your Broadband Modem and to at least one computer. To setup your initial network, follow the steps below: Current Setup BROADBAND MODEM COMPUTER BROADBAND MODEM BarricadeTM Setup BARRICADE ROUTER COMPUTER 3 1 CABLE OR DSL ETHERNET CABLE CABLE OR DSL ETHERNET CABLE 2 ETHERNET CABLE POWER CORD 1 Unplug your existing Broadband Modem s Ethernet cable from the back of your computer. 2 Connect this same Ethernet cable connector to the WAN/ port on the BarricadeTM Router. 3 SMCBR14VPN Using the Ethernet cable included in the box, connect one end to LAN Port-1 on the BarricadeTM Router and then connect the other end to the Ethernet port connection on your computer. 4 4 Finally, when you have connected both your Broadband modem and computer to the Router, you can connect the BarricadeTM s power cord into an available electrical outlet. EZ Installation CD When you have completed the network setup outlined in the previous section, put the SMC EZ Installation and Documentation CD into your CD-ROM drive. For initial setup, it is recommended that you use the EZ 3-Click Install Wizard on the computer that was originally connected to your Broadband Internet connection. Using The EZ 3-Click Wizard The EZ 3-Click Wizard should auto-run to display the splash screen below. If it does not browse the contents of your CD-ROM drive and double-click on the Router icon. [. . . ] If you are using any other operating system, please configure the BarricadeTM through the web-based interface. SMC is a registered trademark; and BarricadeTM is a trademark of SMC Networks, Inc. Other product and company names are trademarks or registered trademarks of their respective holders. [. . . ]