User manual SMART PART SHOCKER SPORT TURBO

[. . . ] Shocker Sport TM Manual Includes: Shocker Sport 4X4 TM and Shocker Sport TurboTM WARNING!The user and any person within range must wear eye protection designed for paintball use. Recommended at least 18 years old to purchase, 14 years old to use with adult supervision, or 10 years old to use on paintball fields meeting ASTM standard F1777-97. When gassing and de-gassing the marker's system, never aim the gun at another person. [. . . ] Once this is done you can pull the grip back and see the battery pack. Note: It is important that the on/off switch be turned off after each day of play. Replacement battery packs are available through Smart Parts and their distributors. Disassembly of the Shocker SportTM TM Before attempting any disassembling of the Shocker SportTM: remove all sources of paint and air, remove the barrel, and disconnect the battery pack. Failure to follow these precautions may result in damage to the gun and/or N grievous injury N to operator or bystanders. The disassembly of the Shocker SportTM into its three main parts is easy. Usually it is not necessary to remove the grip frame and the solenoid housing from the body to do normal maintenance of the components in the body. If you need to access the body or firing chamber skip down to the second paragraph in this section. This is done using a 5/32" Allen wrench to loosen and remove the two screws holding the two parts together. If you have a front handle it takes the place of the front frame screw. Note: Use caution when separating the grip frame from the solenoid housing. The four body screws must be loosened and removed using a Phillips screwdriver. Once this is done the solenoids must be disconnected from the circuit board. Disconnecting the solenoids is accomplished by unplugging the connector from the board itself. The body of the gun is the only part that can really be disassembled any further. A schematic of the bolt and its replacement seals is shown on page 13, figure 1. The circuit board also features a built in safety switch (battery on/off switch). Two different circuit boards are available for the Shocker, the 4x4TM and the TurboTM board. Another option available through Smart Parts is the VL Revolution loader kit. Instead of being controlled by the seeing eye, the loader is controlled by the trigger pull of the Shocker SportTM. The new loader also has a speed adjustment feature, which allows you to adjust the speed of the motor in your loader. This loader also has a battery saving feature that can extend the life of your loader batteries. Your marker has been factory set for optimum performance of both fire and bolt action. [. . . ] If your ball rolls out the barrel easily, your paint may be too small or your barrel may be too big. If you can blow the ball out of the barrel with minimal force then your bore size is just right. Note: It is best to try this with a number of paintballs as they may vary from ball to ball. 2. Please call Smart Parts at 1-800-992-2147. How-to guides are also available at http://www. smartparts. com. [. . . ]