User manual SLENDERTONE SYSTEM-ABS

[. . . ] 2) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 3) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 7) Using the right salt and in the right quantity will help you maintain your dishwasher in top condition, to wash better and to avoid possible damage caused by limescale. [. . . ] The salt container is situated underneath the lower rack, fill it up as follows: 1. Pull out the lower rack completely, unscrew and remove the container cap 2. First fill the container up with water (you won't have to do this again next time) 3. Put the dishwasher funnel on the hole and pour in approximately two kilos of salt. The salt container should be filled up when the low salt indicator light "T" flashes. Once you have loaded the salt for the first time, it is normal that the low salt indicator light stays on or flashes for about 5 consecutive cycles. Salt adjustment Your dishwasher can adjust its salt consumption according to the hardness of the water in your home. This way, you can optimise and customise your dishwasher's salt consumption (not too much, nor too little). Water Hardness Water in your home Never without salt D ISHWASHER To prevent rust from forming, load the salt just before beginning a wash cycle. There is an arrow on the neck of the container (see figure): if necessary, turn the arrow anticlockwise from the "-" setting to the "+" setting. Select the arrow position depending on the water hardness, referring to the table provided. Water supply in the event of leaks This electric household appliance inside the appliance. It is further should be connected to the water equipped with a water inlet hose mains using the cold water supply comprising an outer clear hose and hose provided with the appliance an inner red hose, which can both only. in withstand extremely high presthe event of replacements , use sures. The outer hose will consequently Connect the cold water supply turn red. Safety in the event of hose to a 3/4 gas threaded connec- flooding is ensured by the second tion, placing the small filter clear hose that contains the former. Provided between the hose and It is vital that you check the outer connection, taking care to screw it hose regularly: if you see it has tightly onto the tap. Turned bright red, then you know If the water hoses are new or have you have to replace it as soon as been out of use for an extended possible. Call for an authorised period of time, let the water run to technical engineer to come and make sure it is clear and free of replace it. Check the power supply wire on a regular basis; if it is damaged, we recommend you have it replaced by an authorised technical Assistance service centre. The plug The dishwasher plug must be accessible so that maintenance can be done safely. First of all, check that the mains voltage and frequency values correspond to those stated on the rating plate located on the stainless steel inner door of the appliance and that the electrical system to which the dishwasher is connected is sized for the maximum current indicated on said rating plate. [. . . ] Do not worry about removing every single bit of food residue from your dishes, but do get rid of bones, peel and rind and any other left-overs before placing them in the racks. 10 ARISTON DISHWASHER - Instructions for installation and use Stay in touch D ISHWASHER THANK YOU for choosing an Ariston appliance. We are confident you have made a good choice and that your new appliance will give many years of excellent service. This will confirm your entitlement to free spare parts for five years, and you could also be lucky enough to recover the cost of your purchase in our quarterly prize draw. [. . . ]