User manual SKIL 7302

[. . . ] If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] Name Volts Amperes Hertz Watt Kilograms Minutes Seconds Diameter No load speed Rated speed Revolutions or reciprocation per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Li-ion RBRC seal Rotational speed, at no load Manufacturers rated speed Revolutions, strokes, surface speed, orbits etc. Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. Grounding terminal Alerts user to warning messages Designates Li-ion battery recycling program Designates Ni-Cad battery recycling program Alerts user to read manual IMPORTANT: Some of the following symbols may be used on your tool. Proper interpretation of these symbols will allow you to operate the tool better and safer. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories, to United States and Canadian Standards. This symbol designates that this tool is listed by the Canadian Standards Association. This symbol designates that this tool is listed by the Canadian Standards Association, to United States and Canadian Standards. This symbol designates that this tool is listed by the Intertek Testing Services, to United States and Canadian Standards. This symbol designates that this tool complies to NOM Mexican Standards. Disconnect the plug from the power source before making any Model number Voltage rating Amperage rating No load speed WARNING the power source before making any assembly , adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. BACKING PAD REMOVAL/INSTALLATION Your Multi-Finishing sander is equipped with a hook- and-loop rubber backing pad which may Be removed and attached without the need of additional tools. To remove, press the pad/plate unlock button and pull the backing pad free from the sander (Fig. ) To install, engage rear of backing pad under latched in tool's recess and press front of backing pad in place until it engages with a "Click" sound (Fig. ROTATING BACKING PAD For maximum use of abrasive, rotate pad 120 degrees when tip of abrasive becomes worn Fig. INSTALLING SANDING SHEETS Your sander uses hook-and-loop backed sandpaper, which firmly grips the backing pad when applied with moderate pressure. To change, merely peel off the old sandpaper, remove dust from the backing pad if necessary, and press the new sandpaper in place. Be sure to align the sanding sheet holes with the holes in the backing pad to allow the dust extraction system to function (Fig. After considerable use the backing pad surface will become worn, and the backing pad must be replaced when it no longer offers a firm grip. If you are experiencing premature wear of the backing pad facing, decrease the amount of Pressure you are applying during operation of the tool. The attachment support plate allows you to easily attach and change the position of accessories provided. [. . . ] Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not at tempt to clean by inserting pointed objects through openings. Some of these are: gasoline, carbon tetrachlo ride, chlo rinated cleaning solvents, ammonia and household detergents that contain ammonia. WARNING necessary, a cord with Adequate size conductors that is capable of carrying the current necessary for your tool must be used. [. . . ]