User manual SKIL 4395

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. While the tool may appear to work, the electrical components of the AC rated tool are likely to fail and create a hazard to the operator. [. . . ] Rotational speed, at no load Per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Li-ion RBRC seal Zero speed, zero torque. Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. Grounding terminal Alerts user to warning messages Designates Li-ion battery recycling program This symbol designates that this tool is listed by the Canadian Standards Association, to United States and Canadian Standards. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates This symbol designates that that This symbol designates this tool is listed by that this tool is listed by this tool Underwriters Laboratories, to complies the Canadian Standards United States and Canadian to NOM Association. This symbol designates that this tool is listed by the Intertek Testing Services, to United States and Canadian Standards. Disconnect the plug from the power source before making any WARNING always disconnect plug from Power source before assembling parts, making adjustments, or changing blades. Insert the saw blade (teeth in cutting direction) until it latches in the plunger (Fig. When inserting the saw blade, the back of the blade must rest in the groove of the guide roller (Fig. To remove blade, lift tool-less blade change cover up with index finger and thumb and remove blade. VARIABLE SPEED CONTROLLED TRIGGER SWITCH Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger. The speed can be adjusted from the minimum to maximum nameplate SPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. "LOCK-ON" BUTTON The "Lock-ON" button, located in the handle of your tool allows for continuous operation at maximum SPM without holding the trigger (Fig. TO UNLOCK THE TRIGGER: squeeze trigger and release it without depressing the "LockON" button. If the "Lock-ON" button is continuously being depressed, the trigger can not be released. LASER LIGHT GUIDE (Model 4495 only) The laser light guide is a class IIIA laser with a maximum output power of 5. DO NOT use tinted glasses Tinted glasses will reduce overall vision for the application and interfere with the normal operation of the tool. Bright shiny reflective sheet steel or similar reflective surfaces are not recommended for laser use. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. PLUNGER SPEED The stroke rate may be adjusted as described earlier under "Variable Speed Controlled Trigger Switch". [. . . ] Insert bar of rip fence through the slots provided in foot, from either side of foot with the edge guide facing down (Fig. Thread the clamp screw through threaded hole in tab on either the left or right side of foot, and securely tighten clamp screw with a screwdriver against rip fence bar (Fig. STRAIGHT CUTTING Once the rip fence is attached, measure from the edge of work to the line of cut, and set edge guide of rip fence to the same distance and then securely tighten clamp screw (Fig. Before attaching the rip fence, draw a circle and drive a finishing nail in the center of circle. [. . . ]