User manual SKIL 2895

[. . . ] Failure to follow all instructions listed below may In all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. If operating the power tool in damp locations is unavoidable a Ground Fault Circuit Interrupter (GFCI) must be used to supply the power to your tool. GFCI and personal protection devices like electrician's rubber gloves and footwear will further enhance your personal safety. [. . . ] For forward rotation, (with chuck pointed away from you) move the lever to the far left. Do not change direction of rotation until the tool comes to a complete stop. bRAKE When the trigger switch is released it activates the brake to stop the chuck quickly. This is especially useful in the repetitive driving and removal of screws. gEAR SHIFTING Your tool is equipped with two separate gear ranges , Hi-torque and High-speed. Hi-torque provides high-torque and slower drilling speeds for heavy duty work or for driving screws. To mount, insert mounting bolt into mounting hole, and simply thread handle onto bolt until tight. BATTERY CHARGED CONDITION INDICATOR The battery is equipped with a charged condition indicator (Fig. The indicator lights shows the charged condition of the battery during the working process. By pressing the battery fuel indicator button, the charged condition can also be checked when the battery is removed or when the machine is not in use. When all five lights are illuminated, this indicates the batter pack is fully charged. When only three lights illuminate, this indicates the battery pack is partially charged. â· When only one light illuminates, this indicates the battery pack is slightly charged. When no lights illuminate, this indicates the battery pack is completely discharged. The drill " " position will lock up the clutch to permit drilling and driving heavyduty work, and also enables bits to be changed quickly and easily in the keyless chuck. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Insert the short arm of a 1/2" hex key wrench and close jaws on flats of wrench. Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle (Fig. Open the chuck all the way, remove left-hand thread screw inside chuck Do not use the power of INSTALLING CHUCK Always keep the spindle threads, the threads of the chuck and securing screw free of debris. REMOVABLE ACCESSORY POD Your tool is equipped with a removable accessory pod located on top of your tool (Fig. * STUD FINDER ACCESSORY POD Your tool may be equipped with a stud finder located on top of your tool. Before first use, open the battery compartment door and remove the protective plastic insert from between the batteries. [. . . ] RUNNING NUTS AND BOLTS Variable speed control must be used with caution for driving nuts and bolts with socket set attachments. The technique is to start slowly, increasing speed as the nut or bolt runs down. If this procedure is not followed, the tool will have a tendency to torque or twist in your hands when the nut or bolt seats. If both hands are holding the drill, they cannot be cut by the hole saw. [. . . ]