User manual SKIL 1400

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. [. . . ] Some dust created by power IMPORTANT: Some of the following symbols may be used on your tool. Proper interpretation of these symbols will allow you to operate the tool better and safer. Name Volts Amperes Hertz Watt Kilograms Minutes Seconds Diameter No load speed Rated speed Revolutions or reciprocation per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Li-ion RBRC seal Rotational speed, at no load Manufacturers rated speed Revolutions, strokes, surface speed, orbits etc. Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. Grounding terminal Alerts user to warning messages Designates Li-ion battery recycling program Designates Ni-Cad battery recycling program Alerts user to read manual IMPORTANT: Some of the following symbols may be used on your tool. Proper interpretation of these symbols will allow you to operate the tool better and safer. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories, to United States and Canadian Standards. This symbol designates that this tool is listed by the Canadian Standards Association. This symbol designates that this tool is listed by the Canadian Standards Association, to United States and Canadian Standards. This symbol designates that this tool is listed by the Intertek Testing Services, to United States and Canadian Standards. This symbol designates that this tool complies to NOM Mexican Standards. Disconnect the plug from the power source before making any Model number No load speed Voltage rating Oscillating Angle WARNING the power source before making any assembly , adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Such preventive safety measures reduce the risk of injury from sharp edges of the accessories. Assure that pin in holder are engaged into holes in accessory and securely tighten with with hex bolt provided (Fig. Your accessories can be engaged into accessory holder 12 positions 30 degrees apart. Disconnect the plug from For intermediate position an adapter is provided that will allow you to attach the accessory in any position. Use of adapter will also allow you to use most competitor accessories. Your tool uses hook-and-loop backed sandpaper, which firmly grips the backing pad when applied with moderate pressure. To change, merely peel off the old sandpaper, remove dust from the backing pad if necessary, and press the new sandpaper in place (Fig. After considerable use the backing pad surface will become worn, and the backing pad must be replaced when it no longer offers a firm grip. [. . . ] Move the tool in long steady strokes parallel to the grain using some lateral motion to overlap the strokes by as much as 75%. Excessive pressure will result in poor handling, vibration, and unwanted sanding marks. SAWING Sawing accessories are suitable for sawing thin sheet steel, wood and plastics. WARNING performed by unauthorized per so n nel may result in misplacing of internal wires and components which could cause serious hazard. [. . . ]