User manual SINGER 2852 LIST OF PARTS SEWING MACHINE

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. , declares that this MEXBT3900U is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [. . . ] Connecting the last-connected cellular phone from this unit 1 Be sure the cellular phone is switched to Bluetooth signal on. Some cellular phones require permission to access their phonebook data during handsfree connection to this unit. While streaming Bluetooth audio, you cannot connect from this unit to the cellular phone. With Bluetooth signal on: when the ignition is turned to on, this unit reconnects automatically to the lastconnected cellular phone. You can also select the Bluetooth Phone source by pressing and holding (BROWSE). Once the unit is connected to the cellular phone, you can make/receive handsfree calls by operating this unit. Be sure that both this unit and the audio device are switched to Bluetooth signal on. The built-in microphone of this unit is located on the rear of the front panel (page 12). You can select an auto answer setting from "OFF, " "1 (about 3 seconds)" or "2 (about 10 seconds)" (page 31). You can switch the ringtone from "1 (this unit)" or "2 (cellular phone)" (page 31). * Depending on the cellular phone, this unit's ringtone may be output even if set to "2 (cellular phone). If you activate voice dialing with a cellular phone connected to this unit, this function may not always work in some cases. Noises such as the engine running may interfere with sound recognition. In order to improve recognition, operate under conditions where noise is minimized. Voice dialing may not work in some situations, depending on the effectiveness of the cellular phone's recognition function. Listening to music from an audio device You can listen to music of an audio device on this unit if the audio device supports A2DP (Advanced Audio Distribution Profile) of Bluetooth technology. Operations other than the above should be performed on the audio device. Even if the source is changed on this unit, playback of the audio device does not stop. Tip You can connect a cellular phone that supports A2DP (Advanced Audio Distribution Profile) as an audio device and listen to music. The volume level is adjustable for any difference between the unit and the Bluetooth audio device. 4 Rotate the control dial until "BTA VOL" appears, and rotate the volume control dial to adjust the input level ("+18dB" ­ "0dB" ­ "­ 8dB"). You can perform the following operations on this unit if the audio device supports AVRCP (Audio Video Remote Control Profile) of Bluetooth technology. [. . . ] Phone sound quality depends on reception conditions of cellular phone. T Move your car to a place where you can enhance the cellular phone's signal if the reception is poor. The disc has been forcibly inserted upside down or in the wrong way. T Install the unit at an angle of less than 45° in a sturdy part of the car. [. . . ]