User manual SINGER 14K9

[. . . ] The “separate double flame” burner This burner consists of two concentric burners which can operate either together or separately. Use of the double flame on the maximum setting gives a very high power which reduces cooking times with respect to conventional burners. Moreover the double flame crown provides a more uniform distribution of heat on the bottom of the pan, when using both burners on minimum. In the case of the smaller pots and pans we recommend the use of only the internal burner. [. . . ] The burner is fitted with an electronic igniter that automatically starts when the knob is pressed in. To identify the type of burner, refer to the designs in the section entitled, "Burner and Nozzle Specifications". This will also increase the life of the pots and of the ceramic glass surface as well. Do not use the same cookware that you use for gas burners because the concentrated heat they produce can deform the bottom of the pot. Therefore, you will not achieve best results when using these pots on the ceramic glass surface. Notice: The glue used to seal the glass surface may leave traces on the appliance. We recommend that the module be cleaned with a non-abrasive cleaner before being used the first time. During the first few hours of use, you may detect the smell of rubber; this will disappear after a short time. It may occur that the cooktop does not function or does not function properly. Before calling customer service for assistance, lets see what can be done. First of all, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. Important: Unplug the electrical connection before performing any maintenance or regulation upkeep work. Positioning for gas hob Important: this unit may be installed and used only in permanently ventilated rooms according to the British Stancards Codes Of Practice: B. The following requirements must be observed: a) The room must be fitted with a ventilation system which vents smoke and gases from combustion to the outside. This must be done by means of a hood or electric ventilator that turns on automatically each time the hood is operated. Are not fitted with a safety device to prevent the flame from accidentally going out must have a ventilation opening twice the size otherwise required, i. Otherwise, the room can be vented indirectly through adjacent rooms fitted with ventilation ducts to the outside as described above, as long as the adjacent rooms are not shared areas, bedrooms or present the risk of fire (Fig. B c) Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e. Opening a window or increasing the power of the air intake system (if present). D) Liquidified petroleum gases are heavier than air and, as a result, settle downwards. Rooms in which LPG tanks are installed must be fitted with ventilation openings to the outside in order to allow the gas to escape in the event of a leak. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. [. . . ] The appliance is fitted with an adjustable, "L" shaped connector and a gasket for the attachment to the gas supply. Should this connector have to be turned, the gasket must be 16 475 mm Hook position for H=30mm top Hook position for H=40mm top replaced (supplied with the appliance). The feeding connector of the gas to the appliance is threaded 1/2 gas male cylinder. Connection to flexible steel tube The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe. [. . . ]