User manual SINGER 111W155

[. . . ] This appliance has a polarized plug (one blade wider than the other) to reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. When leaving this sewing machine unattended, the main switch of the machine must be switched off or the plug must be removed from the socketoutlet. When servicing the sewing machine, or when removing covers or changing lamps, the machine or the electrical set must be disconnected from the supply by removing the plug from the socket-outlet. If your sewing machine is fitted with a 3 pin non rewireable BS plug then please read the following. [. . . ] NOTE: For your safety, make sure that the front cover is closed when operating the machine. How to attach and remove the presser foot ⷠTurn off the main power switch or disconnect the 1 (2) Set the needle to its highest position by turning the hand wheel 2 counter clockwise. (3) Push the button on the presser foot holder and the standard foot will be released. 3 4 (4) Raise the presser foot farther by pushing the presser foot lever upward. (5) Again, raise the presser foot farther by pushing the presser foot lever upward. Then place a presser foot just under the presser foot holder A so that the groove in the bottom of the presser foot holder B is aligned and catches the bar on the top of the foot C. CAUTION Always be sure to turn off the power before carrying out this operation. This machine is equipped with two sets of feed dogs under the presser foot to move the fabric through the machine. The differential feed controls the movement of both the front and the rear feed dogs. When set at 1, the feed dogs are moving at the same speed (ratio of 1). When the differential feed ratio is set at less than 1, the front feed dogs move slower than the rear feed dogs, stretching the fabric as it is sewn. CAUTION Always be sure to turn off the power before carrying out the following operation. Run the thread in the sequence illustrated, following the yellow color and the numbers next to each threading point. Pass each thread from 333 to 444 as · Pass the thread through the proper thread Slide and hold the thread tension release button to the right, then pass the thread through the tension disc which is in the channel next to the tension adjustment dial. Run the thread in the sequence illustrated, following Run the thread in the sequence illustrated, following the green color and the numbers next to each threading point. (1-9) CAUTION When needle threading, always thread in this order: Left needle, center needle and then right needle. A To left needle B To center needle C To right needle D Branching plate E Pull about 6 cm (about 2-1/2 inches) of thread through the eye of the needle. CAUTION Always be sure to turn off the power before carrying out the following operation. Pass each thread from 3 to 4 as shown in · Pass the thread through the proper thread · slide and hold the thread tension release Button to the right, then pass the thread through the tension disc which is in the channel next to the tension adjustment dial. 2 Run the thread in the sequence illustrated, following the blue color and the numbers next to each threading point. (1-0) 3 After running the thread to 0, pull the release lever A, and then run the thread through B and C. 4 With about 10 cm (4 inch) of thread pulled through the eye of the needle, as shown by D in the illustration, move the looper back in the direction of the arrow to lock it. [. . . ] Lightly tighten the screw at the unused needle position, so it does not fall out while sewing. Tension adjustments (1) First, set each thread tension dial to the number shown below. CAUTION Make sure that the thread is properly seated in the tension discs by holding the tension release button to the right while passing the thread through the tension discs. ) (3) Adjust the tension of each thread according to the condition of the stitch. [. . . ]