User manual SINGER 107W11

[. . . ] Turn the thread tension adjustment dials for the upper looper thread and needle thread both clockwise to obtain a thread tension higher than normal. How to use the cording presser foot Gebrauchanweisung des Biesendrückerfußes Comment utiliser le pied-guide cordonnet Modo de utilizar el pie prensatelas de acordonado Come usare il piedino per inserimento cordoncino If you are using a 2-needle overlock machine, remove the left-hand side needle. The following types of thread will assure beautifully finished seams every time. [. . . ] Raise the presser foot, and make chain-off stitches 3 to 5 cm in length (test sewing without the material on the machine). Pull the gut gimp slightly away from you so that you can easily make the chain-off stitches. How to use the gathering presser foot Gebrauch des Kräuseldrückerfußes Comment utiliser le pied presseur à emperler Mode de usar el prensatelas de fruncidos Come usare il piedino per arricciare Pressing the feed plate, put the gathering presser foot under the presser holder sideward, and lower the presser bar lifting lever. Feed regulating knob Lower knife adjusting knob Overedging width change-over knob Differential feed regulating knob Turn the handwheel to make the machine sew two or three stitches to secure the material cloth. Put the cloth, while fitting the edge of lower cloth that has been cut in step (1), against the upper knife until the needle position is reached. (3) Put the upper cloth between the gathering presser foot and the feed plate until the needle position is reached. Holding the material cloth with your left hand, gradually feed the material forward while guiding it with your right hand. How to use the beading presser foot Gebrauch de Zierbiesendrückerfußes Comment utiliser le pied presseur à emperler Modo de usar el prensatelas der perlado Come usare il piedino per bordatura perlinata Raise the beading presser foot, put pearl beads under the presser foot so that they are fed from the rear of the presser foot. How to use the Curve/Pearl foot Verwendung des Bogen-/Perlfußes Comment utiliser le pied pour courbes/perles Modo de usar el pie de Curva/Avalorio Come usare il piedino per applicazione di perline su curvature * Maximum diameter of pearls or sequins that can be used Remember: Larger beads may get stuck in tunnel or inhibit the looper movement. Again turn the hand wheel toward you securing the beads or sequins to the fabric. Curves must be pre-cut and fabric should be directed toward the needles, not the knife, when serging curves. 2) Position beads and sequins Raise the presser foot, lay beads or sequins on the plate between the needle and the knife areas. Carefully lower the presser foot making sure that the beads or sequins are in the tunnel and move freely. Turn the hand wheel toward you for 2 or 3 stitches to secure the beads or sequins. Position the fabric under the foot near the needle area to begin serging. 4) Ending a curve application When you reach 50­75mm (2"­3") from the end stop, measure and cut sequins or beads. [. . . ] Position the fabric under the foot near the needle area to begin serging. 4) Ending a curve application When you reach 50­75mm (2"­3") from the end stop, measure and cut sequins or beads. Proceed to finish the circle by stitching over the first few beads or sequins. [. . . ]