User manual SIMPLETECH 60000-00036-001

[. . . ] Attach a phone line to the wider two-wire jack in the line access cable. If you want to use the voice features and your computer does not have a microphone and speakers, attach a handset to the narrower four-wire jack in the line access cable. There is no industry standard for the signal polarity of handsets; therefore, the handset jack does not work with all handsets. [. . . ] If you want to use the voice features and your computer does not have a microphone and speakers, attach a handset to the narrower four-wire jack in the line access cable. There is no industry standard for the signal polarity of handsets; therefore, the handset jack does not work with all handsets. To attach to a cellphone. Refer to the Quick Installation Guide that came with the cellphone cable for instructions on how to install the cellphone driver. Refer to the installation sheet that came with the communications software for instructions on how to install and start the communications software. To use the voice capabilities of the modem, be sure to configure the communications software for the appropriate microphone and speakers. Double-click on the PCMCIA icon located on the right of the task bar; B. When prompted, push the eject button on the computer (if applicable) and pull the modem from the socket. ! Page 2 Simple Installation Guide Installation with Windows 3. x For installations with Windows NT, Windows 95, OS/2 Warp or MacOS, refer to the other pages. With MS-DOS 6 or higher, this will load the drivers in CONFIG. SYS one line at a time. When prompted, press "Y" to load each driver and look for messages indicating that Socket Services Release 2. 1 (or higher) and Card Services Release 2. 1 (or higher) are loading. If you require Card and Socket Services, contact your computer manufacturer for a copy and install Card and Socket Services before continuing D. If you have Card and Socket Services installed, let the computer boot to the DOS prompt. The computer may respond with a tone when the computer recognizes the modem. Attach a phone line to the wider two-wire jack in the line access cable. If you want to use the voice features and your computer does not have a microphone and speakers, attach a handset to the narrower four-wire jack in the line access cable. To attach to a cellphone. Refer to the Quick Installation Guide that came with the cellphone cable for instructions on how to install the cellphone driver. Refer to the installation sheet that came with the communications software for instructions on how to install and start the communications software. [. . . ] Make sure the computer is not accessing the modem, then drag its icon into the Trash. The modem is ejected. ! 4 Use the modem with your favorite OS/2 Warp communications software. Refer to the installation guide that came with the communications software for instructions on how to install and start the communications software. [. . . ]