User manual SILVERCREST URC 801

[. . . ] 97 2 - English Universal Remote Control URC 801 Safety Instructions Before you use this device for the first time, please read the following notes in this manual and heed all warnings, even if you are familiar with handling electronic devices. If you sell the device or pass it on, it is essential you hand over this manual also. Operating Environment Position the device on a stable, even surface and do not place any objects on the device. The device is not for use in environments with a high temperature or humidity (e. [. . . ] English - 13 Universal Remote Control URC 801 Quit the programming mode by pressing the EXIT button (28) twice. You may for instance cover the remote control transmitter at the front of the remote control when the wrong code number is going to be sent. In this case, try to program the remote control by using the learning function (see page 14) and the original remote control unit (if you still have it). 14 - English Universal Remote Control URC 801 Learning Function For this you must have the original remote control unit of the device you want to program, and this remote control unit must be working properly. The learning function lets you have the original remote control unit teach the different button functions to your new universal remote control. This lets you add or edit any specific buttons that do not work properly when using a preset device code or control a device whose device code is not available. Learning a Key Code Signal Place the original remote control unit of the device with its transmitter side (front) facing towards the universal remote control (see figure). Press the source device selection button (2) of the device you want to program. Press the button that you want to assign on the universal remote control. Press and hold down the button on the original remote control which you want to copy the signal from for at least 3 seconds. After releasing the button, the message [SUCCESS] or [FAILED] appears on the display. If you see the message [SUCCESS], the command has been programmed successfully. If necessary, you may repeat the last two steps English - 15 Universal Remote Control URC 801 to copy another command and assign it to a different button. After all the desired buttons have been programmed, quit the programming mode by pressing the EXIT button (28). It is not possible to exit programming while the universal remote control is still waiting for a command to be sent from the original remote control (the display shows [WAITING]). Quit the programming mode by pressing the EXIT button (28) three times. Erasing a Key Code You may erase a learned key code without altering any of the other programmed functions. Press the source device selection button (2) of the device for which you want to edit the programmed information. The message [DELETED] will appear for a few seconds and the device returns to the previous menu [SELECT KEY]. If required, continue erasing more key functions by pressing the corresponding button or quit the deletion process by pressing any source device selection button (2). 16 - English Universal Remote Control URC 801 Erasing All Key Codes for a Device This function allows you to erase all manuallylearned key commands for a specific device. Any buttons that have been programmed via a device code will not be erased. [. . . ] Pressing the FAV button (18) multiple times will cycle through all available preset favourites. Erasing Favourites Press and hold the SET button (23) for at least 3 seconds. The message [DELETED] will appear for a few seconds and the device returns to the [SETUP] level. 26 - English Universal Remote Control URC 801 Backlight Press the LIGHT button (21) to switch on the backlight illumination. [. . . ]