User manual SILVERCREST URC 1001

[. . . ] Before you use this device for the first time, please read the following notes in this manual and heed all warnings, even if you are familiar with handling electronic devices. If you sell the device or pass it on, it is essential you hand over this manual also. Position the device on a stable, even surface and do not place any objects on the device. The device is not for use in environments with a high temperature or humidity (e. [. . . ] if the device fails to respond as desired , press the button (8) to recall the next available device code. Universal Remote Control URC 1001 If the most important device functions work correctly, press the OK button (22) to save the setting. If your device is a VCR or a CD or DVD player, please also insert a tape or CD/DVD. To cancel the following programming at any time, press EXIT (23) to return without saving any changes. Press the EXIT button (23) multiple times until the remote control has returned to standard mode. Proceed as follows to enter the device codes directly (this example refers to programming a TV set). Search for the first available code by using the device type and manufacturer (see the list starting from page 97). Enter the four digits of the device code that you have found on the list. Universal Remote Control URC 1001 After you have entered the information, the first digit will blink again. If you mistyped the code, you have the chance to enter it again at this time. Only for the device type AUX, a fifth digit must be entered to set the device code. After a few seconds, the display will return to the device code entry mode. If the device fails to respond as desired, try the next device code from the list. This may take a very long time and should be used only if the above methods do not succeed. If your device is a VCR or a CD or DVD player, please also insert a tape or CD/DVD. To cancel the following programming at any time, press EXIT (23) to return without saving any changes. Press the EXIT button (23) multiple times until the remote control has returned to standard mode. Proceed as follows to search for the device code automatically (this example refers to programming a TV set). Make sure that the TV set has been powered on and that the remote control points towards the TV set. Universal Remote Control URC 1001 If you have pressed the PAUSE button (12) too late, you can use the button (8) to return step by step to the previous device codes to check them again. If these device codes do not work, you can use the button (8) to go back to the device code where the scan was stopped. As soon as the TV set powers back on, the proper device code has been found. [. . . ] programming Favourites This function supports the source device buttons TV and STB only. It is also possible to program favourites on the AUX button, but this will have to be configured first for TV or STB mode. Press the source device selection button (2) of the device for which you want to add one or more favourites. If necessary, press the or (8) button to select another sequential number to save your favourite. [. . . ]