User manual SILVERCREST SZA 28 A1 DVB-T INDOOR AERIAL

[. . . ] Children should be supervised to ensure that they do not play with the appliance. To disconnect, always pull the plug itself out of the mains power socket, do not pull on the power cable. Arrange for defective plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. [. . . ] Always pull the plug out of the power socket if you are not using the room antenna for a longer period of time. In the event of a heavy storm or a thunderstorm with lightning, equipment connected to a mains power supply could be damaged. Therefore, always unplug the antenna from the mains power supply during a thunderstorm. The programme signals are received by the indoor antenna and transmitted to the television set. For the reception of DVB-T transmitter signals you need a TV with an integrated DVB-T Tuner or an additional DVB-T Receiver (DVB-T signals are not available everywhere). the indoor antenna has to be positioned correctly for the proper reception of programme signals. The following antennas are available for this: 1 two telescoping antennas for VHF and UKW reception that tilt and rotate by 180° and 2 one oval-shaped antenna for UHF reception that tilts and rotates by 100°. µ When you want to use the room antenna for radio reception, utilise the Adapter Coaxial socket/Coaxial socket 8. connect the Adapter Coaxial socket/Coaxial socket 8 with the antenna cable. Connect the anntenna cable with Adapter Coaxial socket/Coaxial socket 8 to the 75 Ohm connector on your stereo system. µ µ µ Pull out both telescopic antenna 1 and adjust these until the best reception is obtained. Adjust the oval antenna 2 by turning or tilting until the best reception is obtained. To connect the room antenna to a DVB-TReceiver with an F-socket, the Adapter F-Plug/ Coaxial socket 7 must be used. Screw the antenna cable with the Adapter F-Plug/Coaxial socket 7 to the F-socket of the DVB-T-Receivers. You can regulate the amplifier gain by turning the regulator 4 on the front of the appliance: µ Switch on the indoor antenna by turning the regulator 4 to the right. µ Turn the regulator 4 completely to the left until it clicks to switch off the indoor antenna. µ Insert the power plug of the indoor antenna into the power socket. Reception disruptions, such as an unclear or distorted picture could have the following causes: · For this reason, reorient the indoor antenna every time after changing the station. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made under warranty. [. . . ]