User manual SILVERCREST SWW 1500 A1

[. . . ] WARNING A warning of this danger level signifies a possible dangerous situation. If the dangerous situation is not avoided it could lead to physical injuries. CAUTION A warning of this danger level signifies possible property damage. This device is only intended for heating in indoor living spaces and only for private purposes. [. . . ] The minimum distances of the housing from other objects must be maintained, they are; 100 mm at the sides, 300 mm above, 150 mm below (with wall mounting) and 500 mm in front. Do not stand and/or hang the device in a hot, wet or very moist environment or in the vicinity of flammable materials. The mains wall socket must be easily accessible so that the mains power cord can be easily removed in an emergency. Environment temperature range: +5 to +45 °C Humidity (no condensation): 5 - 90 % DANGER Fire hazard through contact with materials!The risk of fire exists if the heating elements come into contact with flammable materials!Do not place and/or hang the device in the vicinity of curtains and other flammable materials. Before initial use remove all packaging materials and all transport securing devices from the device. NOTICE With initial use, for a brief period, a light odour accumulation can occur. For safe and faultless operation of the device with electrical connection observe the following advice: CAUTION Before connecting the device compare the connection data (voltage and frequency) on the rating plate with that of your mains power supply. Make sure that the mains power cord is not damaged and is not running over hot surfaces and/or sharp edges. CAUTION For assembly place the device on a soft underlay such as, for example, a carpet in order to avoid damages. Fold the carrying handle 10 backwards and place the device with the underside upwards, on a soft underlay. WARNING Make sure that when you are drilling you do not damage any electrical wires or other installations in the wall such as water pipes. the supplied rawlplugs are only suitable for a mounting on concrete or stone. Before starting the installation, please check your installation location carefully for its suitability for the rawlplugs. NOTICE When selecting the mounting location make sure that a suitable mains wall socket is located within the plug-in radius of the mains power cord. Slide the upper wall brackets B into the holding fixtures C on the device's rear panel and firmly screw these, together with the angle bracket D and the lower wall brackets B , to the rear panel of the device. For this purpose use the 7 screws M4 x 13 mm (see diagram Wall bracket assembly). Diagram Wall bracket assembly Mark two drill holes at a height of 600-650 mm and at a distance of 330 mm. Mark two more drill holes at a height of 250-300 mm and at a distance of 330 mm. Make sure that the distance between the upper and lower drill holes is 350 mm (see diagram Drill scheme). Now with an electric drill and an 8 mm drill bit drill four holes to a depth of, at least, 40 mm. [. . . ] NOTICE The warranty covers only claims for material and manufacturing defects, but not for transport damage, wearing parts or for damage to fragile components, e. This product is for domestic use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorised service branch. The warranty period is not extended by repairs made under the warranty. [. . . ]