User manual SILVERCREST SWKS 2400

[. . . ] Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. Switching off the appliance is not sufficient because the appliance receives power as long as the power plug is connected to the sokket. Always heat water with the lid closed, otherwise the automatic cut-out may not function. [. . . ] The appliance switches itself off and the control lamps 6 go out as soon as the water is on the boil. ­ the appliance, the plug and the power cable are in good working order and. Fill the appliance with water up to the MAX mark and let it come to a full boil once ­ as described in the next section. Fill the appliance with water up to the MAX marking on the scale 7 and then bring it to the boil. First remove the plug from the wall power socket before you lift the kettle from the base 4. This avoids the risk that any water splashing out could come into contact with live electrical connections in the base 4, which could cause a short circuit. For safety reasons, the lid 1 should not be opened while the water is boiling or is very hot. Press from the front against the upper lug sitting in the middle of the pouring sieve 8 and at the same time hold it firmly by the flap. Clean the pouring sieve 8 with a lightly moistened dishcloth and under running water. After cleaning it, place the pourer sieve 8 from inside against the opening. Should the scale deposits in the pourer sieve 8 be firmly settled, lay it in a water-vinegar solution, with a ratio of 6:1, for a few hours. An open housing can create the risk of a life-threatening electrical shock. This can create the risk of a life-threatening electrical shock if residual liquid comes into contact with powered components. First, remove the plug from the power socket and allow the appliance to cool down completely. Clean the exterior surfaces and the power cable with a slighly damp cloth. For stainless steel surfaces, you can use appropriate cleaning agents from a specialized dealer. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. ­ minst upp till MIN-markeringen så att apparaten inte överhettas, ­ högst upp till MAX-markeringen så att det inte kokar över. [. . . ]