User manual SILVERCREST SWK 3000 EDS A1 KETTLE

[. . . ] Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. Simply switching the appliance off is not sufficient, as the appliance is under power for as long as the plug is connected to the socket. 5 l In older electrical installations, the building fuse (12A) may be triggered due to the high power consumption. [. . . ] Fill the appliance with water up to the MAX marking on the scale 4 and then bring it to the boil. Do not consume any water that has already stood in the water boiler for longer than one hour. ­ at least to the MIN mark, so that the device does not overheat, ­ no higher than the MAX mark, so that no boiling water spills out. First close the lid and then place the kettle onto the base 3, ensuring that it is is firmly seated on the base 3. The control lamp integrated in the scale 4, as well as the control lamp in the on/off switch 2, indicate that the appliance is now heating itself up. The appliance switches itself off, and the control lamps go out, as soon as the water is on the boil. First remove the plug from the wall power socket before you lift the kettle from the base 3. This avoids the risk that any water splashing out could come into contact with live electrical connections in the base 3, which could cause a short circuit. For safety reasons, the lid should not be opened while the water is boiling or is very hot. Press the retainer at the top of the pourer sieve 5 down and, at the same time, pull the pourer sieve 5 inwards. Clean the pouring sieve 5 with a lightly moistened dishcloth and under running water. This can create the risk of a life-threatening electrical shock if residual liquid comes into contact with powered components. Should the scale deposits in the pourer sieve 5 be firmly established, lay it in a water-vinegar solution having a ratio of 6:1 for a few hours. Before cleaning the appliance, remove the plug from the mains power socket and allow the appliance to cool down. Clean the exterior surfaces and the power cord with a slighly damp cloth. For stainless steel surfaces, you can use appropriate cleaning agents from a specialized dealer. Allow the appliance to cool off completely before putting it into storage. Wind the power cable around the cable retainer on the underside of the base 3. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Fyll apparaten med vatten upp till MAX-markeringen på skalan 4 en gång till och låt det koka upp. [. . . ]