User manual SILVERCREST STO 800 EDS A1 2-SLICE TOASTER

[. . . ] Any other use, and modification of the appliance, is regarded as contrary to the intended use and could increase the risk of accidents. Arrange for defective power plugs and/or cables to be replaced immediately by qualified technicians or by our Customer Service Department. After use, always remove the power plug from the wall socket, this prevents the unintentional switching on of the appliance. [. . . ] Take note that, subject to the demand made on the toaster, the level of browning can vary somewhat with an unvarying adjustment of the browning regulator u!The less the number of slices inserted, the higher is the browning level. Thus, if you are not intending to toast many slices, always adjust the browning regulator u a little lower. Unwrap the power cable from the cable winder on the underside of the appliance. After setting the desired browning level, insert the bread into the toaster slots w. The automatic bread centering device centres the inserted bread in the toaster slots w. When the desired level of browning has been reached the toaster switches itself off automatically and the slices are ejected to the top. This appliance has a lifting function, which makes it easier and safer for you to take the hot slices of toast from the toaster slots w. The toaster switches itself off automatically, the control lamp extinguishes and the bread slices are ejected. Dependent on the setting of the browning level, the bread is either thawed or browned. When toasting, crumbs that fall from the bread are collected in the crumb tray i. The warming function t makes it possible for you to warm bread without browning it. The toaster switches itself off automatically, the control lamp extinguishes and the bread slices are ejected. NEVER lay bread rolls directly onto the toaster, ALWAYS use the bread roll holder q. [. . . ] Wrap the power cable around the cable retainer on the underside of the toaster. The warranty period will not be extended by repairs made under warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]