User manual SILVERCREST SNS 45 A1

[. . . ] These operating instructions are a component of the Nail Studio SNS 45 A1 (hereafter designated as the appliance) and they provide you with important information about the intended use, safety, connection and operation of the appliance. These operating instructions must be constantly kept available close to the appliance. They are to be read and applied by everyone assigned to operate the appliance and to eliminate faults in it. Retain these operating instructions and pass them on, together with the appliance, to a possible future owner. [. . . ] Upon contact with live wires or live components there is a potentially fatal risk!Pay heed to the following safety information to avoid risks from electrical power: Do not operate the appliance if the plug or the power cable are damaged. connect the appliance exclusively to a correctly fused mains power socket. If live connections are touched and/or the electrical or mechanical construction is altered, there will be an increased risk of electric shock. Before you connect the appliance, compare the connection data (voltage and frequency) on the typeplate of the appliance with that for the intended power source. Therefore, select a larger nail tip o and then file the sides into the desired form. Repeat the above described process until you have trimmed all the nails to the desired length and filed them into shape. Before the application, refrain from using any hand creams or the like, because, to make possible the optimal adhesion of the nail tips o the nail surfaces must be completely free from greases. Push the cuticle back with the cuticle pusher w and then remove the transparent skin from the nail plate of your finger. Now treat the nail surface with the sanding block r until the fingernail is no longer shiny. Rub the nails with the finishing solution p so that the last remnants of dust and grease are removed. NOTICE Under no circumstance should you now touch the nail surfaces with your fingers, if you do, they will become greasy again and this will prevent a good bonding!Apply a small drop of nail glue a to the lower part of the nail tip o and distribute it with the aid of the nail glue bottle a on the lower surface. Hold the nail tip o down so that the nail glue a cannot run onto the upper part of the nail tip o. NOTICE Before the first use you must puncture the bottle of nail glue a with a pointed object, such as a needle. If, at a later date, the bottle of nail glue a has become blocked, it can again be opened for use with a needle. Now place the nail tip o at an angle on the natural nail, so that the predetermined edge of the nail tip o lies on the edge of the natural nail. Now tilt the nail tip o with gentle pressure onto the natural nail, so that potential air bubbles are squeezed out . NOTICE Wipe excess nail glue a off with a cotton swab or a paper towel. Hold the nail tip o firmly for 10-12 seconds and, at the same time, press it down with sufficient pressure onto the natural nail. Ensure that no air bubbles are formed and that the tip is glued on perfectly straight. NOTICE There may no longer be a gap under the nail, so that dirt cannot penetrate. [. . . ] WARNING Observe the following safety information to avoid risks and property damage: Repairs to electronic appliances may only be carried out by specialists who have been trained by the manufacturer. Considerable risk to the consumer and damage to the appliance can occur as a result of incompetent repairs. The following table will help with localizing and remedying minor malfunctions: Defect Appliance does not switch on. Do not press too hard on the brush e when you are applying the UV Gel s. [. . . ]