User manual SILVERCREST SHM 600 A1

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. De geselecteerde map wordt nu in het werkvlak weergegeven en alle te bewerken documenten of afbeeldingen kunnen in deze map worden opgeslagen. 12 14:50 Introduction Introduction Information for these operating instructions Congratulations on the purchase of your new appliance. These operating instructions are a component of the mobile Hand Scanner SHM 600 A1 (henceforth designated as the appliance) and they supply you with important information for intended use, safety and connection as well as operation of the appliance. [. . . ] ™¦ Insert the Micro SD memory card with the metal contacts facing upwards into the slot and carefully press the card until it clicks into place. ™¦ Using a blunt and thin object, such as the end of a paper clip, press the button FORMAT . ™¦ Press the button /SCAN to start formatting the Micro-SD memory card. In the display the indicator for the SD card will blink until formatting is complete. 12 14:50 Handling and operation Setting Time and Date ♦ Switch the appliance on with the button /SCAN . ™¦ Using a blunt and thin object, such as the end of a paper clip, press the button TIME SET . In the display appears ## for the year, whereby # # stands for a series of digits that will be changed to match the actual time and date. ™¦ Press the button C/BW ♦ Press the button /SCAN display appears ##. In the GB ♦ Repeat the last two action steps to set the month, day, hour and minute. ™¦ After setting the minute ( ##), press the button TIME SET once again to exit the setting of date and time. 12 14:50 Handling and operation Setting the Scan Resolution ♦ Press the button DPI to choose between either the high resolution (HIGH = 600 dpi) or the low resolution (300 dpi = LOW). Setting the Scan Mode ♦ Press the button C/BW to choose between either the colour mode (COLOR) or the black / white mode (MONO). GB Scanning NOTICE ► To scan, please ensure that the appliance is not connected to a computer and the Micro-SD memory card is inserted. ™¦ Place the document on a flat surface and hold it down firmly with one hand. Ensure that the ), scan area between the markings for the scan width ( which are marked on the side of the appliance, is maintained. ™¦ Hold the appliance pressed flat against the document and press the button /SCAN once. ™¦ Proceed slowly with the appliance over the document whilst keeping your hand steady, so as to achieve the best quality for the scanned document. ™¦ Press the button NOTICE ► To conserve the batteries, the appliance switches off automatically after 3 minutes of not being in use. 12 14:50 Handling and operation Perform calibration NOTICE ► Perform a calibration only if the white balance needs to be reset. A white balance is recommended if it should be that the lightest point in scanned images, which in reality should be white, in fact appears in a shade of grey. ™¦ Place the appliance on the paper supplied for white balance calibration then switch the appliance on with the button /SCAN . ™¦ Press and hold the button C/BW and then press the button /SCAN to switch into calibration mode. [. . . ] - Format the memory card (see section "Formatting the Micro-SD memory card) - Ensure that all cables are connected properly. - The Micro-SD memory card has not been formatted correctly The computer does not recognise the appliance after the connection is made (it has not detected removable medium). 12 14:50 Troubleshooting Defect Possible cause Solution - Clean the scanner lens with the cleaning cloth. To cancel, press the button /SCAN and try to scan the document again at a slower speed. [. . . ]