User manual SILVERCREST SHK 100 B2

[. . . ] Failure to comply with the following instructions can cause personal injury or material damage (electric shock, skin burns, fire). The following safety instructions and hazard warnings are not only intended to protect your own health and the health of others, but also to prevent damage to the heating pad. Please observe these safety instructions and pass on this operating manual together with the heating pad. Never leave children unattended with the packaging material, as it can cause suffocation. [. . . ] Only use the heating pad in conjunction with the control 1 indicated on the heating pad (label), · do not switch the heating pad on if it is folded or bunched up , · Do not cause any sharp creases in the heating pad, · Do not place any objects, e. Hot water bottle or similar, on the heating pad when it is switched on. Do not cover the control 1 and do not place it on the heating pad when the pad is in operation. The electronic components in the control 1 of the heating pad cause the control 1 to heat up slightly during operation. The electronic sensor technology prevents the entire surface of the heating pad from overheating by automatically switching off in the event of a fault. If the safety system switches the heating pad off automatically as a result of a fault, the temperature display on the control 1 will no longer be illuminated when the heating pad is switched on. Safety system / Operation / Cleaning and care Please note that, for safety reasons, the heating pad must not be used after a fault and must be returned to the service address indicated. NOTE: The heating pad switches itself off automatically after about 90 minutes. 5 seconds select the required temperature level to switch the heating pad back on. Switch the heating pad off (Level "0") or take the mains plug out of the socket if you do not wish to use the heating pad after automatic switch-off. NOTE: the heating pad may smell of plastic the first time you use it, but this will disappear after a short period of time. To use the device, first connect the control unit 1 to the heating pad by plugging the plug-in connector 2 and the plug for the control unit 3 together (see Fig. Selecting the temperature: Set the highest temperature level (Level 6) shortly before use. If you are going to use the device for a number of hours, set it to the middle temperature setting (setting 3). Use the heating pad with the textile cover to prevent soiling or damage to the heating pad (particularly if using essential oils and creams). Before cleaning the heating pad, always pull the mains plug out of the mains socket and separate the plug-in connector 2 from the plug for the control unit 3 (see Fig. Do not reconnect the control 1 to the heating pad until the plug-in connector 2 and the heating pad are completely dry. Do not under any circumstances switch the heating pad on to dry help it dry. Do not use chemical cleaners or scouring agents to clean the heating pad or the control unit 1 . Use a dry, fluff-free cloth to clean and care for the heating pad and the control unit 1 . Setting 0: Settings 1+2: Settings 3+4: Settings 5+6: off minimum heat medium heat maximum heat To remove stubborn dirt from the heating pad, you can dampen the cloth or moisten it with a little mild liquid detergent. First open the zip fastener on the textile cover and take out the heating pad. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Allow the heating pad to cool down before storage, otherwise material damage may occur. The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities. [. . . ]