User manual SILVERCREST SDM 800 A1 DOUGHNUT MAKER

[. . . ] Ensure that the power cable never becomes wet or damp during operation. Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. Simply switching the appliance off is not sufficient, as it remains under power for as long as the plug is inserted into the power socket. to avoid the risks of fire or injury: · Parts of the appliance will become hot during operation; you should hold the appliance only by the grip. [. . . ] Note: Alternatively, you can fill a pastry bag with the pastry and squirt it into the donut moulds. Note: If you put too much pastry into the donut moulds it is possible that, during the baking process, the closure of the lid could pop open and the baking surfaces are pressed apart. After no less than 2 minutes you can open the lid to check the baking result. Note: When removing the donuts ensure that you do not damage the coating of the baking surfaces. If you do, it will become harder to separate the donuts from the surfaces. Remove the power plug and, with the lid open, allow the appliance to cool down . Clean the appliance again as described in the chapter "Cleaning and Care". When you have prepared a dough for the Donut Maker, one such as those in the recipes given in this booklet: 1. As soon as the green operating lamp q glows, the appliance is sufficiently warmed up!After baking the last donut remove the plug from the power socket and allow the appliance to cool with the lid open. Allow the appliance to cool off completely before putting it into storage. Wind the power cable around the cable retainer w on the bottom of the appliance. When the housing is open, there is the risk of receiving a fatal electrical shock. Remove the plug from the power socket and allow the device to cool down completely. Under no circumstances may the components of the appliance be submerged in water or other liquids!There would be the risk of a fatal electric shock upon the next use of the appliance should moisture be present in the voltage conducting elements . First of all, clean the baking surfaces with a dry paper towel to soak up the grease residue. Then clean all surfaces and the power cable with a lightly moistened cloth. They could not only damage the appliance, they can also leave traces that would be baked into the next donuts. It is better to lay a wet wash cloth on the encrusted residues in order to soften them. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made under warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]