User manual SILVERCREST SDB 2000 A1 STEAM IRON

[. . . ] You may not open the filler opening of the water reservoir while the iron is in use. Allow the steam iron to cool down first and remove the power plug from the power socket. If the connection lead or device does not work perfectly or is damaged, have it examined and repaired immediately at the service centre. Arrange for defective power plugs and/or cables to be replaced as soon as possible by a qualified technician or by our Customer Service Department to avoid the risk of injury. [. . . ] Figure 1 q Movable cable guide w Temperature control light e Standing foot r Gliding sole t Water nozzle y Filler opening for the water reservoir u Steam amount control i Button for the steam spray o Button for water fog a Temperature control s Handle d Measuring cup You may only use the iron in a closed room and in the private household. When it is cool, place the steam iron in a horizontal position on its gliding sole r. Fill the reservoir with tap water using the measuring cup d, at most to the "MAX" marking. To avoid any danger of suffocation, keep this bag away from babies and children. Should the mains water at your locality be rated as hard, it is recommended that you mix mains water with some distilled water. Otherwise, the jets for the steam blast function could calcify (become blocked) prematurely. To extend the optimal steam blast function, mix mains water with distilled water according to the table. Water hardness very soft / soft medium hard very hard Should the care instructions for an article of clothing not mention ironing, (Symbol ), you should not iron that clothing article. Check the care instructions on the labels of the clothing article whether and at which temperature the clothing article may be ironed. Close the water reservoir filler opening y, making sure it "clicks" shut. Steam ironing is first possible at level 2 (· ), we however recommend level 3 (· ) should be used for steam ironing, because at this level the temperature to generate steam is optimal. When the control light goes out, the chosen temperature w has been reached. This function is suitable for very dry, crumpled or creased materials. The steam spray is especially suited to smoothing places in the laundry that are difficult to access. You must then re-set a suitable temperature with the temperature controller a. Additionally, if you set the steam iron down or just let it cool off, the drip-stop function prevents water leakage from the soleplate r. Let the iron warm up till the control light w cuts off and lights up again. Now steam and boiling water will start emerging from the steam escape holes at the gilding sole r. Release the steam regulator u as soon as the water in the water container is used up. For this purpose, wipe the gilding sole r a few times on a towel or an old cloth. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made under warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]