User manual SILVERCREST KH 2328

[. . . ] Check that the electricity type and mains voltage matches the information given on the type plate. · Do not use the appliance with a damaged connecting cable or power plug. · Arrange for customer service to repair or replace connecting cables and/or appliances that are not functioning properly or have been damaged. · Do not expose the appliance to rain and never use it in a humid or wet environment. -2- · Make sure that the power cord never becomes wet during operation. [. . . ] · If you do not intend to use the CD-Player with Radio for an extended period, remove the batteries. · Always exchange the batteries in a timely manner and use batteries of the same type. · Should the batteries leak, wear protective gloves and clean the battery compartment with a dry cloth. Before first use Providing mains power Setup · Remove the CD-Player with Radio and the accessories from the trans-port packaging. · Insert the connector of the power cable into the power cable plug at the rear of the appliance. The CD Player with Radio automatically recognises when the power cable is connected to a mains power socket and switches itself into mains power operation. Important: Do not permit small children to play with the plastic packaging. · Place the CD-Player with Radio on a level horizontal surface. Place the CD-Player with Radio so, that the flap of the CD compartment can be -4- Usage Switching the appliance on/off and sound source selection The appliance is switched on by you selecting a sound source with the function switch: · CD · Radio 1. Slide the function switch to the position of your desired sound source. 2. To switch the appliance off, slide the function switch to the position "OFF". Radio functions 1. For receiving MW (AM) transmissions, there is an inbuilt reception antenna. In radio operation, turn the whole appliance to a position where the best radio reception is obtained. With the adjustment FM ST radio programmes transmitted in stereo will be played back in stereo. Should the programme be received in stereo at full strength the FM stereo display lights up. Adjusting the volume. You can adjust the sound volume with the volume regulator. · To increase the sound volume turn the volume regulator clockwise. · To reduce the sound volume turn the volume regulator anti-clockwise. Notice: Should the stereo signal in the reception range FM ST be too weak, you can improve it in that you select the adjustment FM. In this adjustment the sound is played in Mono. Using headphones You can connect headphones to the CD-Player with Radio with a 3, 5 mm Stereo jackplug. The headphone connector is to be found at the rear of the CD-Player with Radio. When you have connected the headphones, the loudspeakers are disconnected and you will only hear sound via the headphones. · Insert the headphone jackplug into the headphone connection. 3. Through turning the tuning regulator, the desired radio station can be selected. Attention! Before putting on a set of headphones turn the volume level down to the minimum!Your hearing could be damaged if it is subjected to high volume levels for too long or suddenly! -5- CD Functions Inserting a CD · Select the CD function with the function switch. · To open the CD compartment, press down the flap at the position marked with OPEN/CLOSE and then release it. · Insert the CD, with the printed side upwards, in the middle of the CD compartment. [. . . ] If you send the device please enclose a copy of the proof of purchase (till receipt). The device must be packaged securely for transport and the RMA number must be directly visible. The warranty does not apply to · parts subject to wear and tear · damage to breakable parts such as switches and rechargeable batteries. Improper handling and usage not in accordance with the intended purpose, use of force and any interventions that are not carried out by our authorised service centre will render the warranty null and void. [. . . ]