User manual SILVERCREST KH 2306 MICRO STEREO SYSTEM

[. . . ] Ensure that the power cable never becomes wet or damp during operation. Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. Get customer service to repair or replace connecting cables and/or devices that are not functioning properly or have been damaged. Make sure that liquids or objects are never able to enter into the device. [. . . ] Always change all batteries at the same time and always use batteries of the same type. Should the batteries leak, wear protective gloves and clean the battery compartment with a dry cloth. In radio operation, turn the whole appliance to a position where the best radio reception is obtained. For receiving FM transmissions, the Micro System is equipped with a small wire aerial in the back of the unit. In order to ensure excellent reception with your Micro System, carefully pull out the wire aerial completely. Do not plug the Micro System into the mains power until all connections have been made. Keep the clamp of the respective speaker jack depressed while inserting the wire. Connect the speaker cable of the Micro System's left loudspeaker by plugging it into the double jack marked "L". The jacks for the headset PHONES are located at the front of the Micro System. When headphones are connected, the loudspeakers are switched off and you will only hear sound via the headphones. Listening to music with headset for long periods and at high volume levels can lead to hearing damage!When all of the required connections have been made, insert the plug on the power cable into a wall power socket. The device is now in standby mode and the green stand-by LED is illuminated. Connect the stereo plug of the audio device with the jack AUX IN at the front of the Micro System. While in standby mode, depress the button CLOCK SET for more than two seconds. Within the next 10 seconds use the pushbutton BACK and NEXT ( and on the remote control) to set the time in either 24-hour or 12-hour mode. Within the next 10 seconds use the pushbutton BACK and NEXT ( and on the remote control) to set the hour of the day. Within the next 10 seconds use the pushbutton BACK and NEXT ( and on the remote control) to set the minutes. In order to ensure a continuous display of the clock, even after a power failure or after the mains cable has been removed, please insert the back-up batteries. The green standby LED extinguishes and the display is being illuminated. If you would like to completely shut off the device, remove the power cable from the mains. Switching off the sound To switch the sound completely off, press the button MUTE on the remote control. [. . . ] start the playback of the programmed title by pressing the button PLAY/PAUSE. Press and hold during the playback the button BACK or NEXT ( and on the remote control), until the desired part of the song is located. For all warranty repairs (free of charge), please contact our service department hotline. Bryt strömtillförseln till apparaten före en storm eller ett åskväder om det finns risk för blixtnedslag! [. . . ]