User manual SIEMENS LU29251

[. . . ] They contain important information concerning your personal safety as well as on use and care of the appliance. Please retain the operating and installation instructions for a subsequent owner. dispose of packaging materials properly (see Installation instructions). Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. [. . . ] Do not use or leave the hood without the lamp correctly mounted because of the possible risk of electric shocks. We decline any responsibility for any problems, damage or fires caused to the appliance as the result of the nonobservance of the instructions included in this manual. The most effective method of removing vapours produced during cooking is to: Switch the ventilator ON as soon as you begin cooking. Switch the ventilator OFF a few minutes After you have finished cooking. Lighting: The light can be switched on at any time, Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. grease filters: Metal filters are used to trap the greasy element of the vapours that develop during cooking. Caution: As the filter becomes more and more saturated with grease, not only does the risk of it catching fire increase but the efficiency of the extractor hood can also be adversely affected. Important: By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced. Cleaning the metal grease filters: In normal operation (1 to 2 hours daily), The metal grease filter must be cleaned after 8 to 10 weeks. Important: Metal filters that are saturated with grease should not be washed together with other dishes etc. When cleaning the filters by hand, soak them in hot soapy water first of all. Then brush the filters clean, rinse them thoroughly and leave the water to drain off. Press the catch on the grease filters Insert the clean filters back into the hood. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Mounting: Remove the cover W by rotating the O knobs to 90° , fit the filter inside and lock in place with the central knob O, then close the cover. Replacing the activated carbon filters: The saturation of the activated charcoal Occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every 4 mounths. The activated carbon filters are available from specialist outlets (see Optional accessories). Disposal of old activated carbon filters: Activated carbon filters do NOT contain any harmful substances. [. . . ] If you have any questions or if a fault occurs, please call Customer Service. When you call, please quote the following: Enter the relevant numbers into the box above. ) and FD (production date) are shown on the name plate which can be seen inside the extractor hood after the filter frame has been detached. Hvis man ikke overholder normene for rengjøring av ventilatoren og utskiftning og rengjøring av filtrene, vil dette medføre risiko for brann. [. . . ]