User manual SHRINK POLYMER SYSTEMS HEASHRINK JOINT TO SUIT 2-4 CORE XLPE & SWA & PVC CABLE 0.6 TO 3.6KV TYPE SPA

[. . . ] INSTALLATION INSTRUCTION HEASHRINK JOINT TO SUIT 2-4 CORE XLPE/SWA/PVC CABLE 0. 6 TO 3. 6kV TYPE: SPA © DATE OF ISSUE:- 20. 01. 05 ONLY THREE CORES SHOWN FOR CLARITY X Fig 1 A B STRIP TO ½ LENGTH OF CONNECTOR A B X LONG SIDE SHORT SIDE 1. [. . . ] Note:Mechanical Shearbolt Connectors can be used, but user should advise as Insulation Tubes will need to be increased in size. Position the Tubes centrally over the Connectors and shrink from the centre to one end at a time. Sealants will be visible at Tube ends once fully shrunk. Note:- Heavy Duty Copper Sock is supplied as opposed to Cages for small Multicore and Power Joints up to 50mm2 OUTER SHRINK TUBE Fig 4 6. Wrap the Armour Cage around the joint gap and secure to the Armours at both sides with the Armour Clamps provided (Roll Springs if Copper Sock). Note:- User may need to apply Tape to the Cores to keep the joint profile down, particularly in the case of core crossing. Figure 5 shows Copper Sock secured to Armours With Roll Springs Fig 5 OUTER SHRINK TUBE Fig 6 7. Tape over any sharp points including Clamp Buckles. OUTER SHRINK TUBE Fig 7 8. [. . . ] Before using, User shall determine the suitability of the product for his or her intended use and User assumes all risk and liability whatsoever in connection therewith. © UNITS P1-P3 GROVEMERE COURT BICTON INDUSTRIAL PARK KIMBOLTON CAMBS PE28 OEY TEL: +44 (0) 1480 861001 FAX: +44 (0) 1480 861002 EMAIL: info@shrinkpolymersystems. co. uk WEBSITE: www. shrinkpolymersystems. co. uk [. . . ]