User manual SHERWOOD RX-770

[. . . ] Introduction READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV System Installer : This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as pracitcal. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] HEADPHONE JACK Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening. INPUT SELECTOR BUTTONS Press the button to select the desired input source. TONE BUTTON When adjusting the tone (bass and treble), press this button to select the desired tone mode. Each time this button is pressed, the tone mode is changed to bass or treble. BALANCE BUTTON When adjusting the sound volume balance, press this button to enter the balance mode. BALANCE, TREBLE/BASS UP/DOWN ( ) BUTTONS At the balance mode, adjust the sound volume balance between left and right speakers with these buttons. At the desired tone mode, adjust the tone as desired with these buttons. TONE DIRECT BUTTON Press this button to listen to a program source without the tone effect. MEMORY BUTTON Press this button to store preset stations. TUNING/PRESET MODE BUTTON Press this button to select the tuning mode or the preset mode. NUMERIC BUTTONS(0 ~ 9) Press these buttons to select or to store preset stations directly. TUNING/PRESET UP/DOWN( BUTTONS Press these buttons to tune in the desired stations. Each time this button is pressed, the FM mode is changed to the stereo mode or the mono mode. PRESET SCAN BUTTON Press this button to scan the stations in the preset sequence. VOLUME CONTROL KNOB, UP/DOWN( ) BUTTONS Adjust the volume to a comfortable listening level with this knob or these buttons. DIMMER BUTTON Press this button to select the brightness of the fluorescent displays as desired. Each time this button is pressed, the brightness of all fluorescent displays changes together as follows: ON dimmer OFF SLEEP BUTTON Press this button to activate the sleep timer for a specified period of time. Each time this button is pressed, the sleep time changes as follows: 10 20 30 60 90 OFF Unit : minutes CD PLAYER SECTION - to begin play - to pause play REPEAT A/B - to play a specific part repeatedly , - to skipping backward or forward - to stop play INTRO - to preview each track only for 10 seconds 8 TAPE DECK SECTION DECK SELECTOR A, B- for selecting deck A or B , - to begin reverse or forward side playback. - to stop playback or recording. REMOTE SENSOR This receives the signals from the remote control unit. FLUORESCENT DISPLAY FLUORESCENT DISPLAY STEREO INDICATOR TUNED INDICATOR MEMORY INDICATOR ST TUNED PRESET MEM KHz MHz SLEEP PRESET NUMBER, SLEEP TIME DISPLAY INPUT, FREQUENCY, VOLUME LEVEL, OPERATING INFORMATION, etc. REMOTE CONTROL OPERATION RANGE LOADING BATTERIES Remove the cover. 1 DAS DISCRETE AMPLIFIER STAGE ST TUNED REMOTE SENSOR PRESET MEM KHz MHz SLEEP A B POWER ON STANDBY SPEAKER DIMMER SLEEP A CD B TAPE APE AUX PHONO Load two batteries matching the polarity. REPEAT REPEA A/B CD TUNER INTRO A DECK SEL. TAPE B TREBLE + BASS 2 + T/P MUTE VOL. TUNE MEMO TUNE + FM MODE VOL. P . SCAN 1 2 3 4 5 6 7 8 9 0 REMOTE CONTROL RM 117 RM-117 AAA size) Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. Remove the batteries when they are not used for a long time. Do not use the rechargeable batteries(Ni-Cd type). 9 Operations LISTENING TO A PROGRAM SOURCE Turn the power on. 1 STANDBY POWER ON STANDBY STANDBY POWER ON SPEAKER DIMMER SLEEP STNADBY A B TAPE AUX PHONO or CD REPEAT A/B CD TUNER INTRO ON/STANDBY A DECK SEL. TAPE B TREBLE + BASS + T/P MUTE VOL. TUNE MEMO TUNE · Then this unit is turned on to enter the operating mode. [. . . ] 200 mV Signal to noise ratio, IHF "A" weighted Phono(MM) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 dB Line(CD, TAPE, AUX) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 dB Frequency response Phono(MM), RIAA, 30 Hz~20 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 dB Line(CD, TAPE, AUX), 20 Hz~100 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]