User manual SHERWOOD AX-5505

[. . . ] PAN-EUROPEAN UNIFIED VOLTAGE All units are suitable for use on supplies 220-240 V AC. Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ] Connect your main speakers to the SPEAKER A terminals and use the SPEAKER B terminals for the remote pair located elsewhere in your home. € Be sure to connect speakers firmly and correctly according to the channel (left and right) and the polarity (+ and -). € Do not let the bare speaker wires touch each other or any metal part of this unit. € Never touch the speaker terminals while the AC input cord is connected to the wall AC outlet. Note : For safe amplifier operation, use the speakers with impedance of over 8Ω when you use either SPEAKER A or B terminals and use the speakers with impedance of over 16Ω when you use both SPEAKER A and B terminals. POWER SWITCH Press this switch to enter the power off or the standby mode. BALANCE CONTROL KNOB Adjust the stereo balance between left and right speakers. TONE DIRECT SWITCH Press this switch to bypass the tone (bass and treble) circuitry for pure sound. SPEAKER SELECTOR A, B BUTTONS/ INDICATORS Press the button to switch the desired speakers on or off. LOUDNESS SWITCH Press this switch to emphasize the sound of frequencies that are difficult to hear at low volume levels. € The frequency emphasis varies according to the volume level at which you are listening. INPUT SELECTOR BUTTONS/INDICATORS Press the button to select the desired input source. € When the TAPE 2 MONITOR indicator lights up, other inputs cannot be heard from the speakers. To listen to an input source other than TAPE 2 MONITOR, be sure to set the TAPE 2 MONITOR button to off. HEADPHONE JACK Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening. € When listening with headphones, turn off both SPEAKER SELECTOR A and B buttons. VOLUME CONTROL KNOB Adjust the volume to a comfortable listening level. REMOTE SENSOR This receives the signals from the system remote control unit. Qxp 2010-02-23 오후 2:04 페이지 7 DIGI LINK III System Remote Controls ENGLISH • You can remotely control not only this amplifier but also Sherwood compatible components bearing the DIGI LINK II or III logo. € For system remote control operation, first make the DIGI LINK connections. • In the DIGI LINK III remote control system , if pressing PLAY , etc. On CD player or tape deck, CD or TAPE 2 MONITOR is selected automatically without selecting the input source and then PLAY, etc. [. . . ] Or • You can listen to pure sound that bypasses the tone circuitry. To emphasize the sound of frequencies that are difficult to hear at low volume levels. –Note • Be careful not to set the volume too high when using headphones. ENGLISH Recording with TAPE 1/MD Recording with TAPE 2 MONITOR 1. [. . . ]