User manual SHARP XG-P560W-N SETUP GUIDE

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NOTE The laser component of the UX-1000/1100 is rated Class 1 and complies with 21 CFR 1040. 10 and 1040. 11 of the CDRH standards. This means that the machine does not produce hazardous laser radiation. ABOUT THE TELEPHONE CONSUMER PROTECTION ACT OF 1991 "The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone facsimile machine unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission the following information: (1) The date and time of transmission. [. . . ] Note: The call counter on your answering machine may indicate that voice messages were received, when only fax messages were received. 46 Chapter 7 Answering Machine Hookup How the hookup operates While you are out, all of your incoming calls will be answered by your answering machine and its outgoing message will play. If your fax machine detects a fax tone or a duration of silence equal to four seconds (called "Quiet Detect Time"), it will take over the line and begin reception. Your fax machine listens for a duration of silence because some transmitting machines do not send a fax tone when the fax is sent manually (this means that the person faxing uses the handset to dial and then presses their Start key after listening to your outgoing message). 14 sec. Quiet Detect Time (Initial setting: 4 sec. ) Answering machine answers Sender presses start key (Line goes silent) Fax reception begins Testing for proper operation If needed, test the operation of the hookup as follows. 1 Call your fax machine from an outside phone line. Cover the mouthpiece to ensure that no sounds are transmitted to the fax machine. Your should hear your outgoing message, the beep to leave a message, and then a fax tone four seconds later (four seconds is the initial Quiet Detect Time setting). If the line is disconnected before you hear a fax tone, lower the Quiet Detect Time setting to three seconds and then call your fax machine again. 47 2 3 Chapter 7 Answering Machine Hookup 4 If you still do not hear a fax tone, turn off the Quiet Detect Time function and have callers send faxes by pressing "5", "*", "*" and then their Start key. For more information on this method, see "If it still doesn't work" in this chapter. If you have problems If you have problems with the hookup, first check the following: Is the answering machine connected properly to the fax?One end of the answering machine line should be inserted in the "TEL. SET" jack on the fax, and the other end in the answering machine's telephone line jack. When your fax detects this tone, it will disconnect the answering machine, send a "reception tone" in response, and begin receiving the transmission. If the transmitting fax does not receive a reception tone from your fax within 30 to 40 seconds after dialing, it will usually hang up and automatically redial several minutes later. Since your fax may not be able to detect the transmitting fax's calling tone until after the outgoing message ends, it is important that the answering machine answers the call within two rings and the outgoing message is less than 10 seconds. Otherwise, your fax may not be able to establish communication with the transmitting fax before the latter hangs up. Manual dialing: If the document is being sent by normal (manual) dialing, the transmitting fax machine does not send a calling tone. Instead, the person faxing normally waits until they hear a reception tone and then presses their Start key. In the case of an answering machine hook-up, they will hear your outgoing message instead of a reception tone, and then press their Start key. Instead, your fax must use a function called "Quiet Detect Time" to detect the transmission. This function causes your fax to disconnect the answering machine and begin reception if it detects a certain duration of silence. Your fax is set to automatically begin fax reception if it detects a duration of silence of four seconds. When the person faxing presses their Start key, the line will go quiet, and the transmitting fax machine will wait for a reception tone from your fax. [. . . ] Tire de la bobina vacía hacia el fondo del compartimiento, desenrollando la parte anterior de la bobina de película. Inserte la bobina vacía en el compartimiento de forma que la ruedecilla y la bobina encajen en las ranuras que hay a ambos lados del compartimiento. Enrolle la película ligeramente para templarla; cierre luego la tapa del compartimiento de impresión. Si ha sustituido la película, pulse las teclas siguientes (procedimiento no necesario para la película de muestra incluida con el fax): FUNCTION START Recepción AUTO: El fax suena cuatro veces y comienza a recibir los documentos que entran. Recepción MANUAL: Levante el teléfono cuando suena el fax. [. . . ]