User manual SHARP VZ-1550H

[. . . ] This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. Warning: To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus. Note for users in Australia: " Copyright may exist in material you wish to record. [. . . ] When the power is turned on, you can open or close the control panel by pressing the control panel open/close button. Caution: " Do not push the control panel whilst it is opening or closing. To return to the demonstration mode: When the unit is in the power stand-by mode, press the DEMO button again. When the X-BASS button is pressed, the unit will enter the extra bass mode which emphasises the bass frequencies, and "X-BASS" will appear. To change to a different mode, press the EQUALIZER button repeatedly until the desired sound mode appears. Turn the jog dial to adjust the hour and within 2 minutes, press the ENTER button. Turn the jog dial to adjust the minutes and within 2 minutes, press the ENTER button. Turn the jog dial to select "CLOCK" and within 10 seconds, press the ENTER button. Note: "CLOCK" will appear or time will flash at the push of the DISPLAY button when the AC power supply is restored after a power failure or unplugging the unit. Turn the jog dial to select the 24-hour or 12-hour display and within 2 minutes, press the ENTER button. Note that this can only be set when the unit is first installed or it has been reset. " When the end of the last track is reached during fast forward, "DISC END" will appear on the display and CD operation will be paused. When the beginning of the first track is reached during fast reverse, the disc will start playback automatically. Note: When one of the DISC 1 - DISC 6 buttons is green, it is ready to play that disc. If there is not a disc on the tray, playback will not begin and the button will turn dark. Each time the TIME button on the remote control is pressed during playback or when in the pause mode, the display will change. " If playback is started by pressing the button, repeat or random play will be performed on all discs. " If playback is started by pressing one of the DISC 1 - DISC 6 buttons, repeat or random play will be performed on that disc. To repeat a programmed sequence: Perform steps 1 - 6 in the "Programmed Play" section, select the repeat playback and then press the button. Notes: " After performing repeat or random play, be sure to press the button. " In random play, the CD player will select and play tracks automatically. ) To cancel repeat or random play: Press the PLAY MODE button repeatedly to select the normal play mode. [. . . ] The digital signal from this unit can be recorded by MiniDisc recorders, etc. Use a connection cable for digital recording to connect the unit to the OPTICAL/LINE IN socket of a MiniDisc recorder, etc. Many potential "problems" can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre. [. . . ]