User manual SHARP VC-381GS/GB/N/S

[. . . ] The data is converted into the different file format so that it cannot be re-edited with the software. (The automatic backup cannot be used for the data in the transparent mode. ) You can change whether to enable/disable the automatic backup and the backup interval time. (If you start the software by directly touching a whiteboard file , the whiteboard file opens. [. . . ] If you start drawing another object within 1 second* after you lift the touch pen from the board, the drawn shapes will be determined to be a single object even though they are separate. Less than 1 second After 1 second Both shapes are determined as a single object. You can switch through "Pen 1" to "Pen 3" and "Eraser" by repeatedly pressing Function Button 2 of the touch pen. To change functions using Function Button 2, select the touch panel driver "Properties", and set "Function Button 2" to "Pen Software Link" on the "OPERATION SETTING" tab. In certain cases, such as when a button on the toolbar is touched, the drawn shape will be fixed as an object before the specified time elapses after the touch pen is lifted from the board. The "Pen 1" to "Pen 3" palettes can be used to change the pen function settings. To display the palette, touch the button of the selected pen once again. You can switch through "Pen 1" to "Pen 3" and "Eraser" by repeatedly pressing Function Button 2 of the touch pen. To change functions using Function Button 2, select the touch panel driver "Properties", and set "Function Button 2" to "Pen Software Link" on the "OPERATION SETTING" tab. The eraser function can erase only the objects drawn with the pen function. You cannot use it either to erase the edges of a line to make the line thinner. If set to a higher setting, operations such as enlarging, reducing, and scrolling the sheet may not take place smoothly. If a Sharp multifunction machine is connected to the same network as the computer on which the Pen Software is installed, an image scanned on the multifunction machine can be acquired onto the whiteboard. There are two ways an image can be acquired: using the Network Scanner Tool, and using the Sharp OSA function. The first time you use the Network Scanner Tool, install the Network Scanner Tool on the computer on which the Pen Software has been installed and configure the Network Scanner Tool settings. (Page 23) To acquire an image from a multifunction machine, the Network Scanner Tool must be running on your computer. To print only the currently displayed sheet, touch the To print all sheets on the whiteboard, touch the Store the print settings ahead of time. In the "Setting" dialog box (page 20), touch "Print Current Sheet" or "Print All". Print Sheet Number : Select this to print page numbers, and select the "Position". The settings are the same in both whiteboard mode and transparent mode. However, the contents of the screen will vary depending on which mode is started. (2) Pen/Eraser palette Select this to have the palettes of "Pen 1" to "Pen 3" and "Eraser" close when a pattern is selected from a palette. [. . . ] (8) Interval of handwriting character recognition Set the period until a hand-drawn line is determined as an object. (10) Automatic backup settings Specify whether to back up data automatically in the whiteboard mode. 0 or later must be installed on the computer on which the Pen Software will be used. When the "User Account Control" dialog box appears, click "Yes" (or "Allow"). [. . . ]