User manual SHARP UPV5500

[. . . ] DriveClone Pro User's Guide Copyright Notice No part of this publication may be copied, transmitted, stored in a retrieval system or translated into any language in any form or by any means without the expressed written permission of FarStone Technology, Inc. FarStone grants you the right to use one copy of the enclosed software program ("SOFTWARE") on a single computer. If the SOFTWARE is installed on a network, or more than one user can run the SOFTWARE at the same time, you must purchase an additional license for each additional user or computer. Trademark FarStone® is a trademark of FarStone Technology, Inc. Microsoft, Windows® and MS-DOS® are registered trademarks of Microsoft Corporation. [. . . ] And DriveClone will retry three timed automatically since the next startup. 6. You can also set to run backup daily, weekly, monthly or one time only. Some optional settings will display if you click Advanced, including backup priority, network connection speed, compression mode, password protection, image split and backup description. Review your information and settings, and click Next to launch the backup process. For best results, close all the files you want to back up prior to launching your backup job. Click Finish to return to the main console. Updating a File Backup Job 1. Review your information and settings, and click Next to launch the incremental backup. Click Finish to return to the main console. 4. 2. 3 Back Up My Computer 1. Select the partition(s) or the entire hard disk to back up, and click Next. Tip If you want to restore with Universal Restore later, you must choose your system partition (e. g. Or select a destination location on a hard drive, USB storage medium, or a network location to store the image file. If you want to save one 22 more image copy on the FTP, select Enable offsite copy (optional), and click Settings to configure these below. a. You can select Anonymous if the FTP server is shared to all users in the network. FTP connection retry frequency ­ Enter Retry attempts (Maximum of 100 times), Delay between retries (Maximum of 600s). If the program fails to upload backup data onto FTP server, it will be recorded as logs which can be checked through View Logs. And DriveClone will retry three timed automatically since the next startup. 6. Click Next to continue. 7. You can also set to run the backup daily, weekly, monthly or one time only. Some optional settings will display if you click Advanced, including compression mode, password protection, image split, integrity check, backup priority, backup description and network connection speed. Or click Previous to modify setting(s). 23 Tip If the system is busy, and DriveClone can not start the backup process successfully, DriveClone will try to back up again automatically. 10. Click Finish to return to main console. Creating an Incremental Backup 1. Review your information and settings, and click Next to launch the incremental backup. Click Finish to return to the main console. 4. 3 Restore Console 4. 3. 1 Return to a System Snapshot This feature can be available only if you install System Snapshot and take system snapshots for you system snapshot. Click Restore and then click Return to a System Snapshot on the main interface. [. . . ] A: We recommend running Windows CheckDisk to scan for hard drive errors. A: DriveClone will try to copy all used sectors when performing a Complete or Incremental backup. You may be prompted to skip a bad sector or a job could fail due to bad sectors. 42 Therefore, it's recommended to run Windows Check Disk command to detect and repair hard drive errors, or use utilities provided by your hard drive manufacturer, when attempting to resolve this type of problem. Can DriveClone Pro fix my system after my hard drive has been accidentally formatted or repartitioned? [. . . ]