User manual SHARP SJ/SJD-48/51/55J OPERATION MANUAL

[. . . ] Do not wind the AC cord around the body or otherwise forcibly bend or twist it. 149 SHARP will not be liable nor responsible for any incidental or consequential economic or property damage caused by misuse and/or malfunctions of this product and its peripherals, unless such liability is acknowledged by law. Before using for the first time, remove the attached lithium battery, and install it in the equipment according to the following procedure. If the power cord is unplugged by accident when operating with AC power only, the tax / discount rate and the contents of memory set up will be lost. [. . . ] 1) 3) Wipe the battery well with a dry cloth and place the plus "+" side upward. Connect the power supply plug to an outlet and turn the power switch "ON". On the battery replacement date label found on the back of the unit, write down the month and year when the battery is installed, as a reference for the next battery replacement. 1) The counter will count the number of times that the key has been pressed in addition. note: · Each time the key is used in subtraction, 1 will be subtracted from the count. 2) When the grand total/rate setting mode selector is in the ON position (GT), the counter will count the number of times that the calculation results have been stored in the grand total memory. 3) The memory item counter will count the number of times that the key has been pressed in the addition. note: · Each time the key is used in the subtraction, 1 will be subtracted from the count. Multiplication: The calculator will automatically remember the first number entered (the multiplicand) and instruction. Division: The calculator will automatically remember the second number entered (the divisor) and instruction. You may want to write down the tax / discount rate and other important numbers on a sheet of paper. 1) Turn the power switch "OFF" and unplug the power supply plug from the outlet. Wipe the battery well with a dry cloth and place the plus "+" side upward. Connect the power supply plug to an outlet and turn the power switch "ON". On the battery replacement date label found on the back of the unit, write down the month and year when the battery is replaced, as a reference for the next battery replacement. Do not expose the battery to water or flame, and do not take it apart. ) (with battery) 1 lithium battery, 1 battery replacement date label (attached on the unit's back body), 1 paper roll, 1 ink ribbon (installed) and operation manual Strong impacts, exposure to electrical fields, or other unusual conditions may render the unit inoperative, and pressing the keys will have no effect. If this occurs, you will have to press the RESET switch on the bottom of the unit. The RESET switch should be pressed only when: · Pressing the RESET switch will clear the stored tax / discount rate and other data stored in the memory. Do not use anything breakable or anything with a sharp tip, such as a needle. [. . . ] Do not use anything breakable or anything with a sharp tip, such as a needle. After pressing the RESET switch, connect the power supply plug to an outlet. The rounding selector should be in the "5/4" position unless otherwise specified. The print/item count mode selector should be in the "P" position unless otherwise specified. [. . . ]