User manual SHARP QT-95H

[. . . ] q Attention should be drawn to the environmental aspects of battery disposal. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. [. . . ] To an AC socket Check the setting of the AC voltage selector located on the rear panel before plugging the unit into an AC socket. If necessary, adjust the selector to correspond to the AC power voltage used in your area. selector adjustment: Slide the selector with a screwdriver to the appropriate voltage number. (AC 110 - 127 V or AC 220 - 240 V) AC plug adaptor: In areas (or countries) where an AC socket as shown in illustration 2 is used, connect the unit using the AC plug adaptor supplied with the unit, as illustrated. The AC plug adaptor is not included in areas where the AC wall socket and AC power plug can be directly connected (see illustration 1 ). Notes: q If the unit will not be used for a long period of time, remove the AC power lead from the AC socket. Q Connection of the AC power lead to the unit disconnects the batteries. Insert 10 "D" size batteries (UM/SUM-1, R20, HP-2 or similar) into the battery compartment. Q Installing the batteries incorrectly may cause the unit to malfunction. Replace the batteries when they become weak This may occur even though radio broadcasts are audible. Q Remove the batteries if they are weak or if the unit will not be used for long periods of time. S Mixing from a microphone s Recording of mixed sound and other sources to a cassette tape You can listen to mixed sound from an external microphone and other sources. You can record mixed sound from an external microphone and other sources. To protect the speakers from shock noise and to avoid disturbing noises, set the VOLUME control to minimum. To protect the speakers from shock noise and to avoid disturbing noises, set the VOLUME control to minimum. Q Place the microphone about 10 - 15 cm (46") away from the source. Q If howling occurs, lower the volume or move the microphone as far as possible from the speakers. Caution: When not using the microphone, remove the microphone plug from the MIXING MIC socket. Note: To record the microphone signals only, load a cassette into the cassette compartment, set the FUNCTION switch to TAPE, and then press the RECORD q button. Q Before plugging in or unplugging the headSet the FUNCTION switch to TAPE before connecting or disconnecting any component. (red ¡ right channel, white ¡ left channel) Set the FUNCTION switch to LINE. Notes: q To prevent noise and interference when using the tuner, turn off the power to your CD player. [. . . ] (red ¡ right channel, white ¡ left channel) Set the FUNCTION switch to LINE. Notes: q To prevent noise and interference when using the tuner, turn off the power to your CD player. Q To prevent hum interference, do not place this unit near television receivers. Q When headphones are connected, the speakers are disconnected automatically. [. . . ]