User manual SHARP PC-1403

[. . . ] Note: This equipment have been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Configure the network by setting the name of the computer and workgroup. · To communicate with other wireless enabled computers, set the computer name and the workgroup name. The computer name should be unique and the workgroup name should be same as others. (Refer to the Changing Your Computer Name or Workgroup Name section on page 4-9. ) · To share the folder(s) on the computer with other computers, refer to the Sharing File and Folders section on page 4-9. 4 4-19 Changing Security Mode This section describes how to change the security mode to WEP or WPA-PSK with TKIP or AES. When using the user authentication security technology, consult your network administrator for the mode changes. In the Related Tasks field, click Change the order of preferred networks. 7. In the Preferred networks field, select the network to be given the security change and then, click Properties. Select Open in the Network Authentication pull-down menu and WEP in the Data encryption pull-down menu. Type the same network key as the other device to be communicated with in the Network key and Confirm network key fields. Available letters and digits are following; 5 or 13 characters ASCII format*1 Hexadecimal format*2 10 or 26 digits *1 0 to 9, a to z, and A to Z (The uppercase and lowercase letters are distinguished. ) *2 0 to 9, a to f, and A to F (The uppercase and lowercase letters are not distinguished. ) 8. If necessary, change the key index in the key index fields. 4-20 · The key index options of the computer are 1 through 4. · Some access points and computers have the options 0 through 3. Automatically Switching to Available Network The computer supports the auto-switching function, "Auto Pilot, " automatically to detect one of the available networks registered and switch to it. Run the Network Setup Utility to display the Network Setup Utility window. · To exit from the auto pilot mode, click the icon ( ) again. 4 4-23 4 4-24 CHAPTER 5 Setup Utility This chapter describes how to run the Setup Utility to change settings on the computer. Running Setup Utility With the Setup Utility, you can customize the system configuration information, such as time and date, port assignments, or passwords. The information you have specified is saved in a special area called CMOS RAM, which the system reads every time you turn on the computer. The computer is shipped from the factory with the appropriate setting of the Setup Utility. Leave it as default in normal use. 5 Contents of Setup Utility The Setup Utility consists of five menu pages, as follows: · · · · · Main: Configures basic setting. Advanced: Configures device interface. Exits the Setup Utility or returns to the default values. 5-1 Entering and Exiting Setup Utility 1. Do not close the display cover. Changing Setting of Setup Utility Mouse is disabled in the Setup Utility. For date and time, press Enter on the item to select the value to be changed; then, use minus key or space bar to change the value. Close the Setup Utility according to the steps above. 5-2 Main Menu System Time defines the system time, using the format hour:minute:second (24-hour format). Use Enter key to move the cursor, and minus key or space bar to change numerals. [. . . ] appear? · Your MP series may be still set the user password. Cancel the password using the Password Utility of the DirectHD utility. (Refer to the Canceling User Password section in Chapter 6. ) Trouble with INSTANT PLAY Why doesn't INSTANT PLAY start up when I press the DVD/CD button? · 1. 4. By default, with the display cover closed, the DVD/CD button is disabled. [. . . ]