User manual SHARP PA-3140

[. . . ] Do not use the product in the bath, in locations where it is exposed to rain, or in excessively humid places. Doing so could result in fire, damage or malfunction. Cautions Using the Product Do not place the product in excessively cold locations or near an open flame. Do not place the product where it will be exposed to direct sunlight for extended periods of time (in particular, closed locations such as inside an automobile) or near heating equipment. Doing so could result in deformation or discoloration of the product, or in fire or damage. [. . . ] 17 ITALIANO ESPAÑOL FRANÇAIS DEUTSCH ENGLISH Press the L (+) or M (-) cursor button until the "SPEED" (playback speed settings) screen appears, then press the OK button. The settings screen appears. Skip/Search File skip You can skip to the previous or next file by briefly pressing the 1 (SKIP/SEARCH 5) or 0 (SKIP/SEARCH 4) cursor button. If the current file contains event marking numbers, this procedure skips to the previous or next event marking number. Mode status Stopped SKIP/SEARCH button pressed 5 or 4 Result Displays the previous or next file number. If the current recording contains event marking numbers, the previous or next event marking number is displayed. Displays the next file number and begins playback from the beginning of that file. If the current recording contains event marking numbers, the next event marking number is displayed and playback begins from that number. Displays the previous file number and starts playback from the beginning of that file. If the current recording contains event marking numbers, the recorder displays the previous event marking number and starts playback from the beginning of that event. Playback 4 (File advance) 5 (File rewind) File search This function searches within files in the Fast forward/Fast rewind mode while the left (5) or right (4) SKIP/SEARCH button is held down. If the current file contains event marking numbers, the recorder searches by marked events. 18 Playback 4 (Fast forward) 5 (Fast rewind) Using the earphone You can listen to your recordings through the earphone provided simply by plugging it into the recorder's earphone jack. When the earphone is connected, no sound is played through the speaker. Notes: · Do not turn the volume up too high when using the earphone as this could damage your hearing. Press the L (+) or M (-) cursor button to select the hour. Start time 3 21 ITALIANO ESPAÑOL FRANÇAIS Hold down the ERASE button for approximately 5 seconds or longer. "DEL. ?" appears and the selected folder number flashes. DEUTSCH ENGLISH · The remaining file numbers are adjusted after the file is deleted. 4 5 6 Press the OK button to confirm the displayed hour. Press the L (+) or M (-) cursor button to select the minutes. Press the OK button to confirm the displayed minutes. Use the same procedure to select the hour and minute settings for the end time. After you have confirmed the "minutes" setting, press the OK button. This completes the time setting procedure and returns you to the menu screen. 7 Tip Press the 1 cursor button to go to the preceding setting. · Recording begins slightly before the scheduled recording time. · Settings such as the recording mode and microphone sensitivity used for scheduled recording are those that were set before recording begins. · If the scheduled time is reached while you are playing a recording, playback stops and the recorder starts recording. · If the scheduled time is reached while the digital voice recorder is connected to a personal computer, a flashing indication appears on the display and recording does not take place. To cancel the settings 1 2 3 Display the recording scheduler settings screen. [. . . ] To set the date and time, follow from step 5 of the procedure on page 10. Initialization procedure If resetting the recorder does not remedy the problem, try initializing the recorder. Never initialize the recorder unless absolutely necessary as this will erase all the data on the recorder. This procedure will erase all the recordings stored on the recorder and will reset all the recorder settings (date/time, etc. ) to their initial values. 1 2 Using a ballpoint pen or similar tool, press the reset button on the back of the recorder. When "OK?" appears on the display, press the OK button again. [. . . ]