User manual SHARP MX-M623U START GUIDE

[. . . ] MODEL: MX-M623U MX-M753U DIGITAL MULTIFUNCTIONAL SYSTEM START GUIDE Keep this manual close at hand for reference whenever needed. Caution!The socket-outlet shall be installed near the equipment and shall be easily accessible. Shielded interface cables must be used with this equipment to maintain compliance with EMC regulations. The equipment should be installed near an accessible socket outlet for easy disconnection. Notice for users in the UK MAINS PLUG WIRING INSTRUCTIONS The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable (moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse and of the same rating as the one removed from the plug must to BS1362 marked or be used. [. . . ] When loading paper, make sure that the stack is not higher than the indicator line. 26 LOADING PAPER IN A TRAY A3 large capacity tray To change the paper size of tray 5, see "TRAY SETTINGS OF TRAY 5 (A4 LARGE CAPACITY TRAY)" in the Operation Guide. Press the operation button and wait until the operation button indicator turns off. Gently pull out the paper tray. Insert the paper with the print side face up. Insert the paper and then gently push the tray into the machine. Do not load as shown below. Indicator line The indicator line indicates the maximum height of the paper that can be loaded in the tray. When loading paper, make sure that the stack is not higher than the indicator line. 27 BEFORE INSTALLING THE SOFTWARE This chapter describes the software programs that allow you to use the printer and scanner functions of the machine, the CD-ROMs that contain the software, and the pages where the basic installation procedures can be found. For details on installation procedures, refer to Chapter 1 of the Operation Guide. CD-ROMS AND SOFTWARE The software that can be used with the machine is on the CD-ROMs that accompany the machine and the expansion kits. Before installing the software, make sure that your computer and the machine meet the system requirements described in "VERIFYING SYSTEM REQUIREMENTS" (page 30). SOFTWARE CD-ROM The "Software CD-ROM" that accompanies the machine contains the printer driver and other software. The "Software CD-ROM" consists of 2 discs. · The CD-ROM does not include software for Mac OS 9. 0 to 9. 2. 2/X10. 2. 8/X10. 3. 9. Contact your dealer or nearest authorised service representative if you want software for Mac OS 9. 0 to 9. 2. 2/X10. 2. 8/X10. 3. 9. Contact your dealer or nearest authorised service representative if you want printer driver for PCL5e. Disc 1 Software for Windows · Printer driver These allow the machine to be used as a printer. - PCL6 printer driver The machine supports the Hewlett-Packard PCL6 printer control languages. - PS printer driver The PS printer driver supports the PostScript 3 page description language developed by Adobe Systems Incorporated. - PPD driver The PPD driver enables the machine to use the standard Windows PS printer driver. WHEN THE MACHINE IS CONNECTED TO A NETWORK (page 34) WHEN THE MACHINE WILL BE CONNECTED WITH A USB CABLE (page 1-91 in the Operation Guide) · Printer Status Monitor (can only be used when the machine is connected to a network) This allows you to monitor the status of the machine on your computer screen. INSTALLING THE PRINTER STATUS MONITOR (page 1-101 in the Operation Guide) Software for Macintosh · PPD file This is the printer description file which enables the machine to be used as a PostScript 3 compatible printer. The PS3 expansion kit is required to use the machine in a Macintosh environment. MAC OS X (page 1-109 in the Operation Guide) MAC OS 9. 0 - 9. 2. 2 (page 1-115 in the Operation Guide) · The PS3 expansion kit is required to use the machine as a printer in a Macintosh environment. · The scanner driver and PC-Fax driver cannot be used in a Macintosh environment. 28 BEFORE INSTALLING THE SOFTWARE Disc 2 Software for Windows · PC-Fax driver This enables you to send a file from your computer as a fax using the same procedure as when printing the file. (When the fax option is installed. ) Even if the fax function is not installed, the PC-Fax driver can be updated using the CD-ROM in the Internet fax expansion kit to enable you to send a file from your computer as an Internet fax in the same way as you print a file. INSTALLING THE PRINTER DRIVER / PC-FAX DRIVER (page 34) The following software can be used only when the machine is connected to a network. · Scanner driver (TWAIN driver) This allows you to use the scanner function of the machine from a TWAIN-compliant software application. INSTALLING THE SCANNER DRIVER (page 1-102 in the Operation Guide) · Printer Administration Utility This allows the administrator to monitor the machine and configure machine settings from a computer. To install and use the Printer Administration Utility, see the Readme file and the manual in PDF format on the "Software CD-ROM" (Disc 2). (Substitute the letter of your CD-ROM drive for "R" in the following path. ) R:\Sadmin\Documents\English OTHER CD-ROMS "PRINTER UTILITIES" CD-ROM that accompanies the PS3 expansion kit (for Windows/Macintosh) This contains the display fonts that are used with the PS printer driver. (Install the PS printer driver and Macintosh PPD file from the "Software CD-ROM". ) INSTALLING THE PS DISPLAY FONTS (page 1-104 in the Operation Guide) "PRINTER UTILITIES" CD-ROM that accompanies the Internet fax expansion kit (for Windows) This CD-ROM is used to update the PC-Fax driver on the "Software CD-ROM" so that it can be used to send Internet faxes (PC-I-Fax function). [. . . ] · Mozilla® and Firefox® are registered trademarks or trademarks of the Mozilla Foundation in the U. S. A. · PCL is a registered trademark of the Hewlett-Packard Company. · IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation. · All other trademarks and copyrights are the property of their respective owners. [. . . ]