User manual SHARP LC-26S7E

[. . . ] WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Perform the following steps after confirming the type of antenna connection made with your TV, and the channel type selected in Step 5. 1 Press a/b to select the channel to skip or not, and then press c/d to select "On" or "Off". In order to receive digital air broadcasts, you need a digital broadcast antenna. You can confirm the antenna configuration through the "Antenna Setup - DIGITAL" screen. Standby Mode may be set to either start the TV quickly from standby or conserve energy while on standby. Input the 2-digit channel number to check the signal strength of the selected channel. Make sure the appropriate signal strength of each channel received is obtained. This function allows you to program 4 favorite channels, in 4 different categories. By setting the favorite channels in advance, you can select your favorite channels easily. Press a/b/c/d to select the channel you want to delete, and then press ENTER. You can delete all the favorite channels by selecting "All Data Clear" in step 2 in Deleting favorite channel. No signal off When set to "Enable", the power will automatically shut down if no signal inputs for 15 minutes. Even if you start using the PC and the signal inputs again, the TV stays off. The TV turns on again by pressing TV POWER on the remote control unit. When you start using the PC and the signal inputs again, the TV turns on. Five minutes before the power shuts down, remaining time displays every minute. No operation off When set to "Enable", the power will automatically shut down if there is no operation for 3 hours. When using a digital PC and setting "Mode2" in Power management, the power may not turn back on automatically even if the signal inputs again. If you turn off the power by disconnecting AC cord when setting "Mode2" in power management, the TV may not function properly after turning the power on again. Five minutes before the power shuts down, remaining time displays every minute. Description Bars may appear on the top and bottom with some programs Displays in full screen Description With 480i/480p/720p broadcasts you can change the screen size to the size of your choice. You can output digital audio to an AV amplifier or similar device whose DIGITAL AUDIO INPUT terminal is connected to the DIGITAL AUDIO OUTPUT terminal on the TV. [. . . ] Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Neither the sales personnel of the seller nor any other person is authorized to make any warranties other than those described herein, or to extend the duration of any warranties beyond the time period described herein on behalf of Sharp. The warranties described herein shall be the sole and exclusive warranties granted by Sharp and shall be the sole and exclusive remedy available to the purchaser. Correction of defects, in the manner and for the period of time described herein, shall constitute complete fulfillment of all liabilities and responsibilities of Sharp to the purchaser with respect to the Product, and shall constitute full satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. [. . . ]