User manual SHARP KC-C100E

[. . . ] Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a Pre-Filter, a Washable Deodorizing Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet. The Washable Deodorizing Filter gradually absorbs odours as they pass through the filter. Some odours absorbed by the filters may break down over time, resulting in additional odour. Depending on the usage environment, especially when the product is used in extreme environments (significantly more severe than normal household use), this odour may become strong in a shorter period than expected. [. . . ] The unit humidifies when there's water in the Water Tank, and it operates without humidifying when there's no water in it. When the operation finishes, the unit will return to the prior operation. Please note the fan speed cannot be sdjusted during the CLEAN ION SHOWER MODE. When the Water Tank is empty, the Water Supply Indicator Light will flash to indicate that the Water Tank should be refilled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and the Clean ION SHOWER Mode. In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty. With the unit OFF, press the Lights ON/OFF button for 3 seconds to turn the audible signal ON. Cancellation To cancel the audible signal, with the unit OFF, press the Lights ON/OFF button again more than 3 seconds. Note that if the Power OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the setting will be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to first unplug the power cord, and never handle the plug with wet hands. After 720 hours of use (30days ×24hours = 720 The Indicator Light will turn on after approximately 720 hours of use. Plug the unit in, turn power ON, and press the RESET button for 3 seconds. Even if the filter indicator light is already off, the RESET button should be pressed to reset the maintenance timer. Care Cycle Whenever dust accumulates on the unit or every 2 months Gently remove dust from the sensor opening and the back panel, using a vacuum cleaner attachment or similar tool. Care Cycle Whenever dust accumulates on the unit or every 2 months To prevent dirt or stains on the unit, clean regularly. Wipe with a dry, soft cloth Do not use volatile fluids Do not use detergents For stubborn stains or dirt, use a soft cloth dampened with warm water. Do not use any detergents or chemicals of any kind to clean the filter. Care Cycle Every day when Humidifying Rinse the inside of the tank by leaving a small amount of lukewarm water inside, closing the tank cap firmly, and shaking the tank. Mild household detergents may be used to clean the inside of the tank, but detergent should be diluted and the tank should be thoroughly rinsed to remove all detergent residue. When washing the filter for the first time, the rinse water may be brown. [. . . ] The Recommended Room Size area indicates the space where a certain amount of dust particles can be removed in 30 minutes. *2 · Humidification Amount changes in accordance with indoor and outdoor temperature and humidity. Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 0. For energy conservation, unplug the power cord when the unit is not in use. [. . . ]