User manual SHARP KC-930E

[. . . ] Before using this product, be sure to read the section: "Important Safety Instructions. " After reading this manual, retain it in a convenient location for future reference. When using electrical appliances, basic safety precautions should be followed, including the following: Read all instructions before using the unit. Do not use the unit if the power cord or plug is damaged or the connection to the wall outlet is loosened. [. . . ] When using in the Humidify Mode, the Water Tank should be filled with water. Remove the Water Tank Cap and carefully fill the Water Tank with tap water. Be sure to wipe off any excess water on the outside of the Water Tank. When carrying the Water Tank, hold it with both hands so that the Water Tank opening is facing up. Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other damaging substances, deformation and/or malfunction may occur. Use of other water sources may promote the growth of mold, fungus and/or bacteria. Please select either Humidify mode or Clean air mode operation when operation when using. Unless the power cord has been unplugged, the operations starts in the previous mode it was operated in. When Plasmacluster Ion is ON, the Plasmacluster Ion Indicator Light will turn on. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to first unplug the power cord, and never handle the plug with wet hands. After 720 hours of use (30days × 24hours = 720) The Indicator Light will turn on after approximately 720 hours of use. Even if the Filter Indicator Light is already off, the RESET button should be pressed to reset the maintenance timer. Whenever dust accumulates on the unit or every 2 months Gently remove dust from the sensor opening and the back panel, using a vacuum cleaner attachment or similar tool. In case of heavy dirt, soak the back panel in water with a small amount of kitchen detergent. ) Rinse the back panel repeatedly with clean water to remove the solution residue. Every day when Humidifying Rinse the inside of the tank by leaving a small amount of lukewarm water inside, closing the tank cap firmly, and shaking the tank. Mild household detergents may be used to clean the inside of the tank, but detergent should be diluted and the tank should be thoroughly rinsed to remove all detergent residue. Care Cycle Whenever dust accumulates on the unit or every 2 months To prevent dirt or stains on the unit, clean regularly. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Do not use volatile fluids Do not use detergents Benzene, paint thinner, polishing powder, may damage the surface. When Water Deposits are Difficult to Remove Unlatch the Water Tank first, then remove the tray. [. . . ] If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. By disposing of this product correctly you will help ensure that the waste undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health which could otherwise arise due to inappropriate waste handling. In other Countries outside the EU If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal. For Switzerland: Used electrical or electronic equipment can be returned free of charge to the dealer, even if you don't purchase a new product. [. . . ]