User manual SHARP KC-6400E/6500E

[. . . ] Before using this product, be sure to read the section: "Important Safety Instructions. " After reading this manual, retain it in a convenient location for future reference. When using electrical appliances, basic safety precautions should be followed, including the following: Read all instructions before using the unit. Do not use the unit if the power cord or plug is damaged or the connection to the wall outlet is loosened. [. . . ] When not operating in Humidify Mode, turn the mode OFF by pressing the Humidify Mode Selection Button; the Water Supply Indicator Light will turn off. ) The concentrated Plasmacluster Ions (ION SHOWER) will be generated in the room like a shower for 15 minutes, repeating the airflow cycles between strong and gentle. (The Plasmacluster Indicator Light repeats its colour cycles between light and shade. When the operation finishes, the unit will return to the prior operation. When pushing the ION SHOWER button while the ION SHOWER operation mode is working, the unit will return to the prior operation. The operation mode can be switched, and the Indicator Light will turn on. Use the Clean Air Mode and Humidify Mode together to quickly remove house dust floating in the air as well as eliminates odour. 4 sensors (a *Dust Sensor and an Odour Sensor for detecting impurities in the air, and Temperature/Humidity Sensors for detecting temperature and humidity) are used to automatically control airflow volume in accordance with the state of your room. 2 sensors (a *Dust Sensor and an Odour Sensor for detecting Clean Air : AUTO impurities in the air) are used to automatically control airflow volume in accordance with the amount of impurities detected in Humidify : LOW your room, while humidifying gently and quietly in "Humidify LOW" Mode. 2 sensors (a *Dust Sensor and an Odour Sensor for detecting impurities in the air) are used to automatically control airflow volume in accordance with the amount of impurities detected in your room, humidifying vigorously in "Humidify HIGH" Mode. About Automatic Humidify Mode The Temperature/Humidity Sensors control humidity automatically in accordance with changes in room temperature. When operating Clean Air Mode and Humidify Mode together, Humidify Mode takes priority. When the device is running, press the Humidify Mode Selection Button to turn Humidify Mode OFF. Each time the Button is pressed during operation, the Plasmacluster Ion Mode turns ON and OFF and the Plasmacluster ON/OFF Indicator Light turns ON (green) and OFF. Use when the Plasmacluster Indicator Light and the CLEANSIGN Light are too bright. (Please press the Plasmacluster ON/OFF Button for 3 seconds 2 short beeps are generated. When the Plasmacluster ON/OFF Button is released before the 2 short beeps, The Plasmacluster Ion Mode switches between ON and OFF; the CLEANSIGN Light does not turn ON/OFF because only the Plasmacluster Indicator Light turns ON/OFF. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to unplug the power cord, and never handle the plug with wet hands. Care Cycle 1 month To prevent dirt or stains on the main unit, clean as often as necessary. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Inadequate rinsing may cause the detergent odour or changes in the shape/ colour of the main unit. [. . . ] Applicable floor surface area indicates the space where a certain amount of dust particles can be removed in 30 minutes. (JEM1467) · Humidification Amount changes in accordance with indoor and outdoor temperature and humidity. Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 0. For energy conservation, unplug the power cord when the unit is not in use. [. . . ]