User manual SHARP FO-A660

[. . . ] The features and specifications of your new Sharp fax are shown below. 40 numbers Initial starter roll (included with machine): 50 m (approx. 24 average pages with no voice messages recorded, or 20 minutes of voice messages (including OGMs) with no documents in memory) 14, 400 bps with automatic fallback to lower speeds. 6 seconds (only when ECM is on) Horizontal: 8 pels/mm Vertical: Standard: 3. [. . . ] Note: The resolution and contrast settings are only effective for sending a document. Use SUPER FINE for documents containing very small letters or very fine drawings. The document must be loaded before Press RESOLUTION one or more times until the desired resolution and contrast settings appear in the display. The first time you move through the list Of resolution settings, the contrast setting AUTO will appear next to each resolution setting. The second time you move through the list, the contrast setting DARK will appear. Note: In order to transmit in SUPER FINE resolution, the receiving fax machine must also have that resolution. If it doesn't, your machine will automatically step down to the next best available setting. With Normal Dialling, you pick up the handset (or press pressing the number keys. If a person answers, you can talk with them through the handset before sending the fax. Normal Dialling allows you to listen to the line and make sure the other fax Dial the number of the receiving machine by pressing the number keys. Depending on the setting of the receiving machine, you will either hear a fax tone or the other person will answer. If the other party answers, ask them to press their Start key (if you pressed , pick up the handset to speak with them). note: If the transmission is unsuccessful and DOCUMENT JAMMED appears in the display , remove the document as explained on page 90. (This may occur if the other fax machine doesn't respond properly when you attempt to send the document. You can store up to 40 fax or phone numbers in the machine for automatic dialling. To clear a mistake, press If a pause is required between any of the digits to access a special service Several pauses can be entered in a row. Enter a name by pressing number keys for each letter as shown in the chart below. To enter two letters in succession that require the same key, press After entering the first letter. To enter a lower case letter, continue pressing the key for the letter until the Lower case letter appears. To enter one of the following symbols, press or })( Return to Step 2 to store another number, or press the date and time display. Note: The fax machine uses a lithium battery to keep automatic dialling numbers and other programmed information in memory when the power is turned off. With the power kept continuously off, the life of the battery is about 5 years. [. . . ] Document jams will occur if you load more than 10 pages at once or load documents that are too thick (see page 44). A fax has been received in memory because the imaging film needs replacement, you have run out of printing paper, or the paper is jammed. This message may also occur during fax reception if too much data is received before the pages can be printed out. If faxes have been received to memory because printing is not possible (an additional message will indicate the problem), resolve the problem so that printing can continue (see Substitute Reception to Memory on page 66). [. . . ]