User manual SHARP FO-210

[. . . ] Mode is for connecting an answering machine) Single / Multi (99 copies/page) Yes (cannot be used if power fails) 220 - 240 V AC, 50/60 Hz 5 - 35°C 25 - 85% RH Standby: 2. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. Do not disassemble this machine or attempt any procedures not described in this manual. [. . . ] If you use automatic dialling (including Direct Keypad Dialling) to send a fax and the line is busy, the fax machine will automatically redial the number. The fax machine will make three redial attempts at an interval of five minutes. During this time, RECALLING will appear in the display, followed by a two-digit number assigned to the fax job. You will not be able to dial any other locations while the message appears. Under certain conditions (for example if a person answers the call on a Telephone), automatic redialling may stop before two redialling attempts are made. You can scan a document into the fax's memory and send the document from memory. This increases transmission speed and allows you to send a fax to multiple destinations in a single operation. After transmission, the document is automatically cleared from memory. This function allows you to send the same fax to as many as 20 different locations in just one operation. When sending to multiple locations, only auto-dial numbers can be used to Press (or ) until the name of the number appears in the display (if no name was stored, the number will appear). Repeat Steps 3 and 4 for each of the other locations to which you wish to send the fax (maximum of 20). If you use a computer fax modem to send documents on the same line, you must turn this function off in order to prevent your fax from mistakenly attempting to receive documents from the computer fax modem. If desired, you can use a number other than 5 to activate fax reception from an extension telephone. The fax has been set at the factory to automatically reduce the size of received documents to fit the size of the printing paper. If desired, you can turn this function off and have received documents printed at full size. If a document is too long to fit on the printing paper, the remainder will be printed on a second page. Automatic reduction may not be possible if the received document is too Large, contains too many fine graphics or images, or is sent at high resolution. In this case, the remainder of the document will be printed on a second page. In situations where printing is not possible, such as when your fax runs out of paper, the imaging film needs replacement, or the paper jams, incoming faxes will be received to memory. When you have received a document in memory, FAX RX IN MEMORY will appear in the display, alternating with ADD PAPER & PRESS START KEY or CHECK FILM / CHECK COVER / CHECK PAPER JAM. When you add paper (and press When documents are stored in memory, do not turn the power off. Single and multiple copies (up to 99 per original) can be made, enabling your fax to double as a convenience office copier. [. . . ] ⷠCheck the size and weight of the document (see Transmittable Documents on page 25). If there is paper in the tray, make sure it is inserted correctly (take out the stack, align the edges evenly, and then reinsert it in the tray) and then press the START/MEMORY key. These alternating messages appear when there is a problem in the print compartment that prevents printing. Check to see if the imaging film is not loaded properly or if it has been used up and needs replacement. [. . . ]