User manual SHARP EL-2607P/2607PG

[. . . ] Since this product is not waterproof, do not use it or store it where fluids, for example water, can splash onto it. While the memory protection battery is not installed, the tax / discount rate set up will be cleared upon terminating the AC power supply. The tax / discount rate set up will also be cleared when the memory protection battery is removed from the unit. If service should be required on this equipment, use only a SHARP servicing dealer, a SHARP approved service facility or SHARP repair service where available. [. . . ] Division: The calculator will automatically remember the second number entered (the divisor) and instruction. When the Add mode is activated, the decimal point is automatically positioned according to the decimal selector setting. The decimal point floats during successive calculation by the use of or . If the decimal selector is set to "F" then the answer is always rounded down ( ). gRAND TOTAL / RATE SETTING MODE SELECTOR: "GT": Grand Total "· ": Neutral " ": Set this selector to the "RATE SET" position before storing each rate. Enter the adding tax rate, then press · A maximum of 4 digits can be stored (decimal point is not counted as a digit). note: · Be sure to set this selector to the "· " position after storing an each rate. MULTIPLICATION KEY DIVISION KEY MINUS EQUAL KEY PLUS EQUAL KEY CHANGE SIGN KEY MARKUP KEY MEMORY TOTAL CLEAR KEY MEMORY SUBTOTAL RECALL KEY MEMORY PLUS KEY MEMORY MINUS KEY TAX-INCLUDING KEY PRE-TAX KEY PERCENT KEY NON-ADD/SUBTOTAL KEY: Non-add ­ When this key is pressed right after an entry of a number in the Print mode, the entry is printed on the left-hand side with the symbol "#". This key is used to print out numbers not subjects to calculation such as code, date, etc. When pressed following the or key, the subtotal is printed with the symbol "" and the calculation may be continued. By pressing this key even in the Non-print mode, the displayed number is printed with the symbol "P". * Although all available symbols are shown here for instruction purposes, these symbols will not appear on the screen simultaneously. There are several situations which will cause an overflow or an error condition. if an "0· E" is displayed at the time of the error, must be used to clear the calculator. If an "E" with any numerals except zero is displayed, the error may be cleared with or and the calculation can still be continued. also , in rare cases , printing may stop midway and the indication "E" appear on the display. This is not a malfunction but is caused when the calculator is exposed to strong electromagnetic noise or static electricity from an external source. Should this occur, press the key and then repeat the calculation from the beginning. When the integer portion of the contents of the memory or grand total memory exceeds 12 digits. You may want to write down the tax / discount rate and other important numbers on a sheet of paper. [. . . ] If an error is made while entering a number, press or and enter the correct number. % Discount Markup and Profit Margin are both ways of Abschlag calculating percent profit. Knowing Bekannt Quand on connaît Sabiendo Sapere När du känner till U weet Sabendo que Tietäen Sell, Cost Sell, Cost Cost, Mrgn Sell, Mrgn Cost, Mkup Sell, Mkup Cost Sell Cost Sell Cost Sell Calculate the dollar difference (a) and the percent change (b) between two yearly sales figures $1, 500 in one year and $1, 300 in the previous. Perform two calculations using $840 and $525, both of which already include tax. [. . . ]