User manual SHARP CDC471H OPERATION MANUAL PART (FROM THE SERVICE MANUAL)

[. . . ] SETTING THE CLOCK Press the ON/STAND-BY button to enter the stand-by mode. [. . . ] q When the 12-hour display is selected, "AM" will change automatically to "PM". or ) button to adjust the 5 6 3 RESETTING THE MICROCOMPUTER 4 7 8 1 q Press the button for at least 0. 5 seconds to change the time in 5-minute intervals. q The hour setting will not advance even if minutes advance from "59" to "00". 0:00 AM 12:00 AM 0:00 Reset the microcomputer under the following conditions: 5 9 Press the MEMORY/SET button. (Seconds are not displayed. ) q To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets). q If the operation is not correct. OPERATION MANUAL ­6­ 6 2 2 Note: q To erase the tuner preset memory, see "To erase all of the contents of preset memory" on page 18. While pressing down the VOLUME button and the TUNING/TIME button, hold down the ON/STAND-BY button for at least 1 second. 7 Note: q In the event of a power failure or when the AC power lead is disconnected, the clock display will go out. [. . . ] Caution: q The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets. When the unit is on: x Press the CLOCK button. [. . . ]