User manual SHARP CD-BK137W

[. . . ] To obtain the best performance from this product, please read this manual carefully. When the ON/STAND-BY button is set at STAND-BY position, the unit may be brought into operation by the timer mode or remote control. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. Z To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. [. . . ] When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and "X-BASS" will appear. When the unit is in the power stand-by mode, press the EQUALIZER/X-BASS/DEMO button again. When the power is on, the EQUALIZER/X-BASS/DEMO button can be used to select the extra bass mode. To change to a different mode, press the EQUALIZER MODE button repeatedly until the desired sound mode appears. , , To turn the power on Press the ON/STAND-BY button to turn the power on. Press the TUNING/TIME ( or ) button to adjust the hour and then press the MEMORY/SET button. Press the CLOCK button and within 5 seconds, press the MEMORY/SET button. Z The hour will not advance even if minutes advance from "59" to "00". The "CLOCK" or time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. (AM 0:00 - PM 11:59) Note that this can only be set when the unit is first installed or it has been reset. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. Z Be sure to place 8 cm (3") CD(s) in the middle of the disc positions. Total number of tracks on the CD whose number is flashing Total playing time of the CD whose number is flashing To select the CD you want to listen to first, press one of buttons on the remote control. , , To locate the beginning of a track To move to the beginning of the next track: Z You can skip to any track by pressing the / button repeatedly until the desired track number appears. Z Playback will begin from track 1 on the disc you have selected to play. After that disc finishes playing, the next disc will automatically start playback. Z When the last track on the third disc has finished playing, the CD player will stop automatically. Z When there is no CD in one of the disc 1 - 3 positions, that position will be skipped and the next CD will be played. Z You can skip to any track by pressing the / button repeatedly until the desired track number appears. If the power fails whilst the tray is open, wait until the power is restored. If the disc tray is stopped forcibly, "ERR 0203" will appear in the display and the unit will not function. If this occurs, press the ON/STAND-BY button to enter the power stand-by mode and then turn the power on again. [. . . ] Your system will enter the power stand-by mode automatically after the preset time has elapsed. The volume will be turned down 1 minute before the sleep operation finishes. The volume will increase gradually until it reaches the volume you were listening at before your system enters the timer stand-by mode. If you select CD or TAPE, the unit will enter the stand-by mode after the playback. [. . . ]